Mini Size SPDT Slide Switch On-Off 3-Pin 0.3A
220V AC 2000W SCR Voltage Regulator Motor Speed Controller
Features:
- With reverse polarity protection, high current protection high temperature fr-4 circuit board
- Maximum power: 2000w
- voltage: Ac 110-220v
- voltage regulation: Ac 50-220v
- size(lx w): Approx. 46 x 35mm
- how to use: This product series with the lamp or electrical circuit, table lamps, appliances disconnect any firewire or zero line (ie a product two wires connected to both) rotary potentiometer spin rod, you can play light and shade adjustment, speed, pressure, the role of the thermostat, use very convenient. This product is applicable to: The use of new two-way high-power thyristor can be very convenient to adjust the mains current up to 25 a, and solve the the overcurrent problem of the heating wire resistance is too small in the case of cooling causing good, the output voltage is adjusted anywhere between 90 to 220 volts for use with electrical appliances. Such as: Electric stove, water heater tune thermal, lighting dimmer, small motor speed, electric iron thermostat. So as to achieve dimming, thermostats, pressure regulator effect. Large appliances available, power consumption is less than 2, 000 watts of power has sufficient home appliances or small factories. (Inductive or capacitive load power should be reduced, the regulator is equipped with two-way high-power thyristor, potentiometers are with nuts, do not have to add any components will be able to use, very convenient and practical).
33k Resistor – 2 Watt
A resistor is a passive two-terminal electrical component that implements electrical resistance as a circuit element. In electronic circuits, resistors are used to reduce current flow, adjust signal levels, to divide voltages, bias active elements, and terminate transmission lines, among other uses.
(Note: Product Images are shown for illustrative purposes only and may differ from actual product.) Perfect for use in various electronics projects in India, 33k Resistor - 2 Watt ensures reliability and performance. Ideal for various electronics projects, 33k Resistor - 2 Watt offers quality and performance.
1N5822 Diode
6 Pin 2 Way Toggle Switch 3A/5A AC 250V/125V DPDT On Off, 250v for DIY
20 ohm Resistor – 5 Watt
A resistor is a passive two-terminal electrical component that implements electrical resistance as a circuit element. In electronic circuits, resistors are used to reduce current flow, adjust signal levels, to divide voltages, bias active elements, and terminate transmission lines, among other uses.
(Note: Product Images are shown for illustrative purposes only and may differ from actual product.) Perfect for use in various electronics projects in India, 20 ohm Resistor - 5 Watt ensures reliability and performance. Ideal for various electronics projects, 20 ohm Resistor - 5 Watt offers quality and performance.
Soil Moisture Sensor Module for Arduino Raspberry PI
This is a simpleSoil Moisture water sensor, can be used to detectsoil moisture ModuleOutput is high level when the soil moisture deficit, or output is low. Itcan be used in module plant water device, and the plants in your garden no need people to manage. Perfect for use in various electronics projects in India, Soil Moisture Meter, Soil Humidity Sensor, Water Sensor, Soil Hygrometer for Ardunio ensures reliability and performance. Ideal for various electronics projects, Soil Moisture Meter, Soil Humidity Sensor, Water Sensor, Soil Hygrometer for Ardunio offers quality and performance.
LM324 Low Power Quad Op-Amp IC DIP
Features of LM324 Op-Amp
- Internally frequency compensated for unity gain.
- Large DC voltage gain :100dB.
- Wide operating supply range (Vcc=3V~32V).
- Input common-mode voltage includes ground.
- Large output voltage swing: From 0V to Vcc-1.5V.
- Power drain suitable for battery operation.
LM317 Adjustable Voltage Regulator
- The LM317 device is a positive-voltage regulator that can be adjusted to provide an output voltage between 1.25 V and 37 V. It can supply more than 1.5 A of current. The output voltage can be set by using two external resistors. The device has a low line regulation of 0.01% and a low load regulation of 0.1%. It also has protection features such as current limiting, thermal overload protection, and safe operating area protection. These features work even if the ADJUST terminal is not connected.
9.1V 1W Zener Diode (IN4739)
Note-
Product Images are shown for illustrative purposes only and may differ from actual product. Perfect for use in various electronics projects in India, 9.1V 1W Zener Diode (IN4739) ensures reliability and performance. Ideal for various electronics projects, 9.1V 1W Zener Diode (IN4739) offers quality and performance.
3.3k Resistor – 2 Watt
A resistor is a passive two-terminal electrical component that implements electrical resistance as a circuit element. In electronic circuits, resistors are used to reduce current flow, adjust signal levels, to divide voltages, bias active elements, and terminate transmission lines, among other uses.
(Note: Product Images are shown for illustrative purposes only and may differ from actual product.) Perfect for use in various electronics projects in India, 3.3k Resistor - 2 Watt ensures reliability and performance. Ideal for various electronics projects, 3.3k Resistor - 2 Watt offers quality and performance.
