Showing 1–16 of 140 results

• Sale!

  DRV8833 2 Channel DC Motor Driver

  ₹60.00 Original price was: ₹60.00.₹56.00Current price is: ₹56.00. + GST

  Features:

  1. Dual-H-bridge motor driver: can drive two DC motors or one bipolar stepper motor
  2. Operating voltage: 2.7V to 10.8V
  3. Output current: 1.2A continuous (2A peak) per motor
  4. Motor outputs can be paralleled to deliver 2.4A continuous (4A peak) to a single motor
  5. Inputs are 3V- and 5V-compatible
  6. Under-voltage lockout and protection against over-current and over-temperature
  7. Reverse-voltage protection circuit
  8. Current limiting can be enabled by adding sense resistors (not included)

  Add to cart

  Quick View
• Sale!

  Expansion Board For Arduino Sensor Shield V5

  ₹180.00 Original price was: ₹180.00.₹162.50Current price is: ₹162.50. + GST

  The latest Sensor Shield V5 Expansion Board For Arduino is produced by ALSRobot. This Sensor Shield expansion board to retains the advantages of version V4.0 on the basis of stack design, PCB Immersion Gold processing technology. newly added many kinds of interface, for example, IIC interface, 32 channels servo motor interface, Bluetooth communication module interface, …

  Expansion Board For Arduino Sensor Shield V5Read More

  Add to cart

  Quick View
• Sold out!

  LM317T Adjustable Voltage Regulator

  ₹14.00 Original price was: ₹14.00.₹6.50Current price is: ₹6.50. + GST

  • The LM317 device is a positive-voltage regulator that can be adjusted to provide an output voltage between 1.25 V and 37 V. It can supply more than 1.5 A of current. The output voltage can be set by using two external resistors. The device has a low line regulation of 0.01% and a low load regulation of 0.1%. It also has protection features such as current limiting, thermal overload protection, and safe operating area protection. These features work even if the ADJUST terminal is not connected.

  Read more

  Quick View
• Sale!

  74HCT541D SMD

  ₹29.00 Original price was: ₹29.00.₹26.00Current price is: ₹26.00. + GST

  The 74HCT541D is an octal non-inverting buffer/Line Driver with 3-state outputs. The device features two output enables (OE1 and OE2). A high on OEn causes the outputs to assume a high-impedance OFF-state. Inputs include clamp diodes that enable the use of current limiting resistors to interface inputs to voltages in excess of VCC.

  Add to cart

  Quick View
• Sale!

  FT232RL (SMD SSOP-28 Package) USB to Serial UART Interface IC

  ₹199.00 Original price was: ₹199.00.₹195.00Current price is: ₹195.00. + GST

  Applications:-

  • USB to RS232/RS422/RS485 Converters
  • Upgrading Legacy Peripherals to USB
  • Cellular and Cordless Phone USB data transfer cables and interfaces
  • Interfacing MCU/PLD/FPGA based designs to USB
  • USB Audio and Low Bandwidth Video data transfer
  • PDA to USB data transfer
  • USB Smart Card Readers
  • USB Instrumentation
  • USB Industrial Control
  • USB MP3 Player Interface
  • USB FLASH Card Reader and Writers
  • Set Top Box PC – USB interface
  • USB Digital Camera Interface
  • USB Hardware Modems
  • USB Wireless Modems
  • USB Bar Code Readers
  • USB Software and Hardware Encryption Dongles

  Add to cart

  Quick View
• Sale!

  170 Points Mini Breadboard SYB-170 White

  ₹17.00 Original price was: ₹17.00.₹16.00Current price is: ₹16.00. + GST

  Features :

  1. Use: experimental, testing, robot
  2. Matching jumper, diameter 0.8mm
  3. Accepts 20-29 AWG wire sizes.
  4. Adhesive-backed for permanent mounting.
  5. Phosphor bronze nickel plated spring clips

  Add to cart

  Quick View
• Sale!

  Proto Shield (Prototype) for Arduino Uno Mini Breadboard

  ₹120.00 Original price was: ₹120.00.₹81.18Current price is: ₹81.18. + GST

  It has a nice standard 0.1?x0.1? prototyping grid with big pads Comes with Stacking headers and plain header, choose whichever you want when soldering together An IC pattern for adding DIP ICs up to 20 pins Power rails down the middle and sides A reset button and an extra general use button Two 3mm general …

  Proto Shield (Prototype) for Arduino Uno Mini BreadboardRead More

  Add to cart

  Quick View
• 

  Development of IOT Based Whether reporting system (Assembled), 100% Tested Project Kit

  1. Development of IOT Based Whether reporting system (Assembled), 100% Tested Project Kit
  2. Full documentation, includes Free Project CD , Abstract, Presentation PPT ,Project IoT ready Android App ,BOM (Component List ),Schematic/Circuit Diagram Design File, Embedded C Code, Datasheet of Components, Explanation Video, How to Run Video
  3. Videos are available on YouTube for easy understanding
  4. 4. 100% Support on working days 11am ? 9 PM , Email us Smartxbrains@gmail.com
  5. Fastest Delivery all over India

  Read more

  Quick View
• Sale!

  Electronic Components Kit-DIY Projects-Small Prototyping Projects-For Science Projects-For Educational Purposes-For Learning-55 Components

  ₹800.00 Original price was: ₹800.00.₹642.88Current price is: ₹642.88. + GST

  Electronic Components Kit has everything needed to build a prototype. It consists of breadboard, LED, resistors, transistors and other generic components. Useful to build prototype | 55 components | Transistors | Resistors | All-in-one kit | Multiple components Package component count:58(311 pieces) The Electronic Components Kit is assembled for beginners willing to learn about building …

  Electronic Components Kit-DIY Projects-Small Prototyping Projects-For Science Projects-For Educational Purposes-For Learning-55 ComponentsRead More

  Add to cart

  Quick View
• Sale!

  12V 40W Ceramic Cartridge Heater

  ₹149.00 Original price was: ₹149.00.₹57.82Current price is: ₹57.82. + GST

  Features :

  1. Works on many 3D printers, including RepRap and Prusa models.
  2. It fits nicely in our extruder, so its an easy replacement.
  3. Small but powerful.
  4. Get your hot end hot quickly.
  5. This unit is a more powerful unit than the standard unit for many 3D printers.

  ?

  Package Includes :

  1 x12v 40W Ceramic Cartridge Heater.

  Specifications :-

  Voltage(V)	12
  Power(W)	40
  Lead Length(mm)	20
  Lead Diameter(mm)	6
  Wire Length(cm)	100
  Lead Material	Stainless Steel

  Add to cart

  Quick View
• Sale!

  LM3915 LED Dot/Bar Display Driver IC DIP-18 Package

  ₹40.00 Original price was: ₹40.00.₹28.93Current price is: ₹28.93. + GST

  Specification:-

  Parameter	Value
  Power Dissipation (3) PDIP (NFK) 1365 mW	1365 mW
  Supply Voltage	25V
  Voltage on Output Drivers	25V
  Input Signal Overvoltage	+-35V
  Divider Voltage	-100mV to V+
  Reference Load Current	10 mA
  Storage Temperature Range	-55?C to 150?C
  Lead Temperature (Soldering, 10 sec.)	260?C

  ?

  Add to cart

  Quick View
• Sold out!

  TL431 Adjustable Precision Shunt Regulator TO-92 Package

  ₹7.00 Original price was: ₹7.00.₹2.34Current price is: ₹2.34. + GST

  TL431 is three-terminal adjustable regulator series with a guaranteed thermal stability over applicable temperature ranges. The output voltage may be set to any value between VREF (approximately 2.5 volts) and 36 volts with two external resistors. These devices have a typical dynamic output impedance of 0.2?. Active output circuitry provides a very sharp turn-on characteristic, …

  TL431 Adjustable Precision Shunt Regulator TO-92 PackageRead More

  Read more

  Quick View
• Sold out!

  LM3914 Dot/Bar Display Driver IC DIP-18 Package

  ₹78.00 Original price was: ₹78.00.₹22.10Current price is: ₹22.10. + GST

  The LM3914 is a monolithic integrated circuit that senses analog voltage levels and drives 10 LEDs, providing a linear analog display. A single pin changes the display from a moving dot to a bar graph. Current drive to the LEDs is regulated and programmable, eliminating the need for resistors. This feature is one that allows operation of the whole system from less than 3V.

  The circuit contains its own adjustable reference and accurate 10-step voltage divider. The low-bias-current input buffer accepts signals down to ground, or V?, yet needs no protection against inputs of 35V above or below ground. The buffer drives 10 individual comparators referenced to the precision divider. Indication non-linearity can thus be held typically to ?%, even over a wide temperature range.

  Versatility was designed into the LM3914 so that controller, visual alarm, and expanded scale functions are easily added on to the display system. The circuit can drive LEDs of many colors, or low-current incandescent lamps. Many LM3914s can be ?chained? to form displays of 20 to over 100 segments. Both ends of the voltage divider are externally available so that 2 drivers can be made into a zero-center meter.

  The LM3914 is very easy to apply as an analog meter circuit. A 1.2V full-scale meter requires only 1 resistor and a single 3V to 15V supply in addition to the 10 display LEDs. If the 1 resistor is a pot, it becomes the LED brightness control. The simplified block diagram illustrates this extremely simple external circuitry.

  When in the dot mode, there is a small amount of overlap or ?fade? (about 1 mV) between segments. This assures that at no time will all LEDs be ?OFF?, and thus any ambiguous display is avoided. Various novel displays are possible.

  Much of the display flexibility derives from the fact that all outputs are individual, DC regulated currents. Various effects can be achieved by modulating these currents. The individual outputs can drive a transistor as well as a LED at the same time, so controller functions including ?staging? control can be performed. The LM3914 can also act as a programmer, or sequencer.

  The LM3914 is rated for operation from 0?C to +70?C. The LM3914N-1 is available in an 18-lead PDIP (NFK) package.

  Read more

  Quick View
• Sale!

  Rated 5.00 out of 5

  Automatic Hand Sanitizer Using IR DIY Experiments Science STEM KIT (Assembled), 100% Tested

  ₹1,025.00 Original price was: ₹1,025.00.₹409.18Current price is: ₹409.18. + GST

  1. Automatic Hand Sanitizer Using IR Complete assembled Kits 100% Tested .
  2. Full documentation, includes Circuit diagrams, PCB Layout, Testing document, etc.
  3. Videos are available on YouTube for easy understanding
  4.100% Support on working days 11am – 9 PM , Email us Smartxbrains@gmail.com
  5.Fastest Delivery all over India

  Add to cart

  Quick View
• Sale!

  Rated 4.43 out of 5

  Touch Doorbell DIY Experiments Science STEM KIT (Assembled), 100% Tested

  ₹1,025.00 Original price was: ₹1,025.00.₹327.18Current price is: ₹327.18. + GST

  1. Touch Doorbell Complete assembled Kits 100% Tested .
  2. Full documentation, includes Circuit diagrams, PCB Layout, Testing document, etc.
  3. Videos are available on YouTube for easy understanding
  4.100% Support on working days 11am – 9 PM , Email us Smartxbrains@gmail.com
  5.Fastest Delivery all over India

  Add to cart

  Quick View
• Sale!

  Rated 5.00 out of 5

  Automatic Temperature Control Fan DIY Experiments Science STEM KIT (Assembled) , 100% Tested

  ₹1,025.00 Original price was: ₹1,025.00.₹409.18Current price is: ₹409.18. + GST

  1. Automatic Temperature Control Fan Complete assembled Kits 100% Tested .
  2. Full documentation, includes Circuit diagrams, PCB Layout, Testing document, etc.
  3. Videos are available on YouTube for easy understanding
  4.100% Support on working days 11am – 9 PM , Email us Smartxbrains@gmail.com
  5.Fastest Delivery all over India

  Add to cart

  Quick View