Viper22A Low Power Off Line SMPS Primary Switcher
Original price was: ₹40.00.₹25.16Current price is: ₹25.16. + GST
Specification
- VDS(sw) Switching Drain Source Voltage (Tj=25 … 125?C) -0.3 .. 730 V
- VDS(st) Start Up Drain Source Voltage (Tj=25 … 125?C) -0.3 .. 400 V
- ID Continuous Drain Current Internally limited A
- VDD Supply Voltage 0 to 45 V
- IFB Feedback Current 3 mA
- Tc Case Operating Temperature -40 to 150 ?C
- Tstg Storage Temperature -55 to 150 ?C
20 in stock
Viper22A is a high voltage IC, intended to be used in off line power supply switching with advantage of having low part count and small size.
The?Viper22A IC?combines a dedicated current mode?PWM controller?with a high voltage?Power MOSFET?on the same silicon chip. Typical applications cover off line power supplies for battery charger adapters, standby power supplies for TV or monitors, auxiliary supplies for motor control, etc.
The internal control circuit offers the following benefits:
- Large input voltage range on the VDD pin accommodates changes in auxiliary supply voltage. This feature is well adapted to battery charger adapter configurations.
- Automatic burst mode in low load condition.
- Over voltage protection in hiccup mode.
12 reviews for Viper22A Low Power Off Line SMPS Primary Switcher
You must be logged in to post a review.
Related products
-
Crystal Oscillator 8 MHZ
Original price was: ₹15.00.₹6.72Current price is: ₹6.72. + GSTAdd to cartThis is a 8MHZ Crystal. This is a low cost crystal oscillator with?oscillation frequency of 8Mhz. Crystal are normally required to provide?clock pulses to your micro controller or other IC’s which require external clock?source.
An oscillator crystal has two electrically conductive plates, with a slice or?tuning fork of quartz crystal sandwiched between them. The crystal oscillator?circuit sustains oscillation by taking a voltage signal from the quartz?resonator, amplifying it, and feeding it back to the resonator. Quartz has the?further advantage that its elastic constants and its size change in such a way?that the frequency dependence on temperature can be very low.
-
Original Flex sensor 2.2 inches for Motion and Diy
Original price was: ₹400.00.₹240.50Current price is: ₹240.50. + GSTAdd to cartFlex sensors are usually available in two sizes. One is 2.2 inch and another is 4.5 inch. Although the sizes are different the basic function remains the same. They are also divided based on resistance. There are LOW resistance, MEDIUM resistance and HIGH resistance types. Choose the appropriate type depending on requirement. Here we are going to discuss 2.2inch Flex sensor that is FS-L-0055. Perfect for use in various electronics projects in India, Original Flex sensor 2.2 inches for Motion and Diy ensures reliability and performance. Ideal for various electronics projects, Original Flex sensor 2.2 inches for Motion and Diy offers quality and performance.
-
74HC595 8-bit Shift Register IC
Original price was: ₹16.80.₹14.00Current price is: ₹14.00. + GSTAdd to cartThe 74HC595 consists of an 8?bit shift register and an 8?bit D?typelatch with three?state parallel outputs. The shift register accepts serialdata and provides a serial output. The shift register also providesparallel data to the 8?bit latch. The shift register and latch haveindependent clock inputs. This device also has an asynchronous resetfor the shift register.The HC595 directly interfaces with the SPI serial data port onCMOS MPUs and MCUs
-
8 Channel 5V Relay Board Expansion Module Optocoupler compatible UNO Raspberry
Original price was: ₹312.00.₹246.16Current price is: ₹246.16. + GSTAdd to cartSpecification
- This relay module is 5 Volts active low.
- It is an 8-channel relay interface board, which can be controlled directly by a wide range of microcontrollers such as Arduino, AVR, PIC, ARM, PLC, etc.
- It is also able to control various appliances and other equipments with large current.
- Relay output maximum contact is AC250V 10A and DC30V 10A.
- Standard interface can be directly connected with microcontrollers.
- Red working status indicator lights are conducive to the safe use.
- Widely used for all MCU control, industrial sector, PLC control, smart home control.
- Input port IN1, IN2, IN3, IN4, IN5, IN6, IN7, IN8 low signal level effectively.
- VCC, GND : Input power.
- JD – VCC : Relay power input port,relay can power alone.
- Working voltage : 5V
- Module weight : about 112g
- package weight : about 150g
- module size : about 1.7cm X 5.5cm X 13.7cm(height * width * long)
Perfect for use in various electronics projects in India, 8 Channel 5V Relay Board Expansion Module Optocoupler compatible UNO Raspberry ensures reliability and performance. Ideal for various electronics projects, 8 Channel 5V Relay Board Expansion Module Optocoupler compatible UNO Raspberry offers quality and performance.
-
Crystal Oscillator 16 MHZ
Original price was: ₹15.00.₹6.72Current price is: ₹6.72. + GSTAdd to cartCrystal Oscillators are used as a quick and easy way to offer circuits a very accurate and consistent frequency output. This 16 MHz Crystal is a thru-hole type and is typically used with microcontrollers.
Shubham (verified owner) –
Less cost than other websites
Ketan (verified owner) –
I got my project done with these components Great Support
Komal (verified owner) –
Good service.
Shubham (verified owner) –
Less cost than other websites
Prakash (verified owner) –
The product is firmly packed.
Rahul (verified owner) –
Very well worth the money.
Devendra (verified owner) –
I got my project done with these components Great Support
Vikas (verified owner) –
Good quality.
Rohit (verified owner) –
I got my project done with these components Great Support
Ayush (verified owner) –
Good service.
Prakash (verified owner) –
Very well worth the money.
Ketan (verified owner) –
Good techinical knowledge