Category: SMD
SMD
Showing 1–16 of 23 results
- Add to cart
This is a 10nF 50V Multi Layered Ceramic Capacitor in SMD 1206 Package. It has X7R as dielectric, which makes up a highly stable capacitor. It has tolerance of 10% only. Its also denoted as 0.01uF.
This is a 10nF 50V Multi Layered Ceramic Capacitor in SMD 1206 Package. It has X7R as dielectric, which makes up a highly stable capacitor. It has tolerance of 10% only. Its also denoted as 0.01uF.
10uF (10000nF) 50V Capacitor – 0603 SMD
₹3.77 + GSTAdd to cart10uF (10000nF) 50V Capacitor – 0603 SMD Product Images are shown for illustrative purposes only and may differ from actual product.
10uF (10000nF) 50V Capacitor – 0805 SMD Package
₹3.28 + GST1N4007 SMD Diode (SOD123)
₹3.77 + GSTAdd to cartType:?IN4007 Average Rectified Output Current:?1 A Ideally Suited for Automatic Assembly Low Forward Voltage Drop Ultra-Fast Recovery Time. Diodes | SMD | Rectifier SMD Diode
1nF (1000pF) 50V Capacitor – 0805 SMD Package
₹2.46 + GST- Add to cart
- The 74HC165 high speed PARALLEL-IN/SERIAL-OUT SHIFT REGISTER utilizes advanced silicon-gate CMOS technology. It has the low power consumption and high noise immunity of standard CMOS integrated circuits, along with the ability to drive 10 LS-TTL loads. This 8-bit serial shift register shifts data from QA to QH when clocked. Parallel inputs to each stage are enabled by a low level at the SHIFT/LOAD input. Also included is a gated CLOCK input and a complementary output from the eighth bit. Clocking is accomplished through a 2-input NOR gate permitting one input to be used as a CLOCK INHIBIT function. Holding either of the CLOCK inputs high inhibits clocking, and holding either CLOCK input low with the SHIFT/LOAD input high enables the other CLOCK input. Data transfer occurs on the positive going edge of the clock. Parallel loading is inhibited as long as the SHIFT/LOAD input is HIGH. When taken LOW, data at the parallel inputs is loaded directly into the register independent of the state of the clock. The 74HC logic family is functionally as well as pin-out compatible with the standard 74LS logic family. All inputs are protected from damage due to static discharge by internal diode clamps to VCC and ground.
74HCT541D SMD
₹26.00 + GSTAdd to cartThe 74HCT541D is an octal non-inverting buffer/Line Driver with 3-state outputs. The device features two output enables (OE1 and OE2). A high on OEn causes the outputs to assume a high-impedance OFF-state. Inputs include clamp diodes that enable the use of current limiting resistors to interface inputs to voltages in excess of VCC.
- Add to cart
- The 74LS132 contains four independent gates each of which performs the logic NAND function. Each input has hysteresis which increases the noise immunity and transforms a slowly changing input signal to a fast changing, jitter free output.
- Add to cart
The ATMEGA8A is a low-power CMOS 8-bit microcontroller based on the AVR RISC architecture. By executing powerful instructions in a single clock cycle, the ATMEGA8A achieves through puts approaching 1 MIPS per MHz, allowing the system designer to optimize power consumption versus processing speed.
- Add to cart
- BC847 NPN general-purpose transistors comes in Surface-Mounted Device (SMD) plastic packages. It is mainly used in General-purpose switching and amplification.
- Add to cart
- BC857 transistor belong to PNP general purpose transistors. General purpose switching and amplification are the main applications of this transistor.
- Add to cart
Applications:-
- USB to RS232/RS422/RS485 Converters
- Upgrading Legacy Peripherals to USB
- Cellular and Cordless Phone USB data transfer cables and interfaces
- Interfacing MCU/PLD/FPGA based designs to USB
- USB Audio and Low Bandwidth Video data transfer
- PDA to USB data transfer
- USB Smart Card Readers
- USB Instrumentation
- USB Industrial Control
- USB MP3 Player Interface
- USB FLASH Card Reader and Writers
- Set Top Box PC – USB interface
- USB Digital Camera Interface
- USB Hardware Modems
- USB Wireless Modems
- USB Bar Code Readers
- USB Software and Hardware Encryption Dongles
LM358 IC – (SMD Package) – Low Power Dual Op-Amp IC
₹10.40 + GSTAdd to cart- The LM358 series consists of two independent, high gain, internally frequency compensated operational amplifiers which were designed specifically to operate from a single power supply over a wide range of voltages. Operation from split power supplies is also possible and the low power supply current drain is independent of the magnitude of the power supply voltage. Application areas include transducer amplifiers, dc gain blocks and all the conventional op amp circuits which now can be more easily implemented in single power supply systems. For example, the LM358 series can be directly operated off of the standard +5V power supply voltage which is used in digital systems and will easily provide the required interface electronics without requiring the additional ±15V power supplies. The LM358 is also available in a chip sized package (8-Bump micro SMD) using National’s micro SMD package technology.