100K Resistor – 1/4 Watt
₹0.82 + GST
A resistor is a passive two-terminal electrical component that implements electrical resistance as a circuit element. In electronic circuits, resistors are used to reduce current flow, adjust signal levels, to divide voltages, bias active elements, and terminate transmission lines, among other uses.
(Note: Product Images are shown for illustrative purposes only and may differ from actual product.)
252 in stock
A resistor is a passive two-terminal electrical component that implements electrical resistance as a circuit element. In electronic circuits, resistors are used to reduce current flow, adjust signal levels, to divide voltages, bias active elements, and terminate transmission lines, among other uses.
(Note: Product Images are shown for illustrative purposes only and may differ from actual product.)
12 reviews for 100K Resistor – 1/4 Watt
You must be logged in to post a review.
Related products
Quartz Crystal Oscillator 16MHz HC-49S 2 Pin for TV, car Electronics, PC Card, Electronic Watch, DVD, MP3v
₹6.72 + GSTAdd to cartCrystal Oscillators are used as a quick and easy way to offer circuits a very accurate and consistent frequency output. This 16 MHz Crystal is a thru-hole type and is typically used with microcontrollers.5.5mm x 2.1mm 3 Pin Female DC Power Jack Panel Mount Screw Nut Kit DC Socket Electrical Plug
₹8.20 + GSTAdd to cart- Widely used in small-scale as well as prototyping projects where 12 to 30 volts power supply needed
- Supports DC Power Jack: 2.1 x 5.5 mm
- Diameter: 14mm
- Add to cart
1-Channel?Solid-State Relay is some what similar to that of a mechanical relay & the difference is that, there is no moving contact in a Solid-State Relay. Here we make use of Phototropic coupler to turn it ON and OFF.
Voltage Sensor Module 25VDC
₹50.12 + GSTAdd to cartThis DC Voltage Sensor Module is essentially a 5:1 potential divider circuit built using precession resistors for high accuracy.
The Arduino analog input is limited to a 5 VDC input.? If you wish to measure higher voltages,this module allows you to measure voltages of 0-25V. Keep in mind, you are restricted to voltages that are less than 25 volts. More than that and you will exceed the voltage limit of your Arduino input.
- Add to cart
- Decade counter/decimal decode display (CD4017B)
- Binary counter/decoder
- Frequency division
- Counter control/timers
- Divde-by-N counting
- For further application information, see ICAN-6166 “COS/MOS MSI Counter and Register Design and Applications”
Lokesh (verified owner) –
Good techinical knowledge
Ayush (verified owner) –
Drone parts i ordered and found ok
Vivek (verified owner) –
Very well worth the money.
Er.Prashant (verified owner) –
Very well worth the money.
Devendra (verified owner) –
The product is firmly packed.
Rohit (verified owner) –
Very fast delivery.
Mayur (verified owner) –
Good support and recommended
Rohit (verified owner) –
Good quality.
Roma (verified owner) –
Drone parts i ordered and found ok
Sneha (verified owner) –
Good service.
Harsh (verified owner) –
Good service.
Prakash (verified owner) –
Best cost electronic components in India