XT60 Male To T Plug Female Adapter
Original price was: ₹200.00.₹100.00Current price is: ₹100.00. + GST
- Great for adapting your XT60 batteries for use with chargers/ESCs that don’t provide an XT60 adapter
- The quick, easy and affordable solution for your mismatched connector
- Saves you money and soldering time
- Use to convert your battery’s XT90 connector to a T plug Female connector
- Great for use with RC planes, helis, cars, and trucks
1 in stock
1 in stock
5 in stock
2 in stock
41 in stock
SafeConnect XT60 male to T plug female Connector is a handy adapter to convert an XT90 equipped battery to an XT60 plug. Its ultra-small size, lightweight, suitable for the installation of all types of model projects. Useful for use with an XT90 equipped ESC or Charge lead.
You must be logged in to post a review.
Related products
-
Voltage Sensor Module 25VDC
Original price was: ₹16.00.₹15.08Current price is: ₹15.08. + GSTAdd to cartThis DC Voltage Sensor Module is essentially a 5:1 potential divider circuit built using precession resistors for high accuracy.
The Arduino analog input is limited to a 5 VDC input.? If you wish to measure higher voltages,this module allows you to measure voltages of 0-25V. Keep in mind, you are restricted to voltages that are less than 25 volts. More than that and you will exceed the voltage limit of your Arduino input.
-
Single Channel 5v Relay Module with Isolation High Low Level Trigger
Original price was: ₹40.00.₹39.00Current price is: ₹39.00. + GSTAdd to cartRelays are output devices which are used to control or operate some external devices.? This is a 5 volt Isolated relay module which means that there is a optocoupler used in between your control circuit and the relay thus protecting your circuit in case of any short circuit issues on the relay side.
-
BC327 PNP General Purpose Amplifier Transistor
Original price was: ₹5.00.₹1.95Current price is: ₹1.95. + GSTAdd to cartBC327 is a general purpose PNP BJP transistor that can be used for switching and amplification purposes in electronic circuits. The transistor features 800mA collector current hence it can be used to drive variety of loads in an electronic application. The max collector-emitter voltage is -45V therefore it can easily handle load voltage under 45V. Apart from that transistor also features 625mW collector dissipation and DC current gain of maximum 630 therefore it can also be used as an audio amplifier or for any type of signal amplification.
-
DHT11 Module Temperature and Humidity sensor Module for boards compatible with Arduino, ARM and other MCU
Original price was: ₹120.00.₹65.00Current price is: ₹65.00. + GSTAdd to cartThe DHT11 is a commonly used Temperature and humidity sensor. The sensor comes with a dedicated NTC to measure temperature and an 8-bit microcontroller to output the values of temperature and humidity as serial data. The sensor is also factory calibrated and hence easy to interface with other microcontrollers.
-
CD4017-4017 Cd4017 Cd4017Be Cmos Decade Counter with 10 Decoded Outputs Dip16 IC
Original price was: ₹20.00.₹13.94Current price is: ₹13.94. + GSTAdd to cart- Decade counter/decimal decode display (CD4017B)
- Binary counter/decoder
- Frequency division
- Counter control/timers
- Divde-by-N counting
- For further application information, see ICAN-6166 “COS/MOS MSI Counter and Register Design and Applications”
Reviews
There are no reviews yet.