2SB 688 -120V, -8A Transistor PNP
₹41.51 + GST
25 in stock
Specification
- Type Designator: 2SB688.
Material of Transistor: Si.
Polarity: PNP.
Maximum Collector Power Dissipation (Pc): 80 W.
Maximum Collector-Base Voltage |Vcb|: 120 V.
Maximum Collector-Emitter Voltage |Vce|: 120 V.
Maximum Emitter-Base Voltage |Veb|: 5 V.
Maximum Collector Current |Ic max|: 8 A.
Max. Operating Junction Temperature (Tj): 150 ?C.
Transition Frequency (ft): 5 MHz.
Collector Capacitance (Cc): 280 pF.
Forward Current Transfer Ratio (hFE), MIN: 55.
1 review for 2SB 688 -120V, -8A Transistor PNP
You must be logged in to post a review.
Related products
- Add to cart
Relays are output devices which are used to control or operate some external devices.? This is a 5 volt Isolated relay module which means that there is a optocoupler used in between your control circuit and the relay thus protecting your circuit in case of any short circuit issues on the relay side.
- Add to cart
A lithium-ion battery or Li-ion battery is a type of rechargeable battery. Lithium-ion batteries are commonly used for portable electronics and electric vehicles and are growing in popularity for military and aerospace applications.
Voltage Sensor Module 25VDC
₹50.12 + GSTAdd to cartThis DC Voltage Sensor Module is essentially a 5:1 potential divider circuit built using precession resistors for high accuracy.
The Arduino analog input is limited to a 5 VDC input.? If you wish to measure higher voltages,this module allows you to measure voltages of 0-25V. Keep in mind, you are restricted to voltages that are less than 25 volts. More than that and you will exceed the voltage limit of your Arduino input.
- Add to cart
Specification
- Size : 75mm (length) x 55mm (W) x 19.3mm (height);
- Weight : 80g;
- PCB Color : Blue;
- board four weeks with four screw holes, hole diameter 3.1mm, easy to install and fixed;
- Relay selection of quality loose music relays, SPDT. A common terminal, a normally open, one normally closed terminal;
- optocoupler isolation, good anti-jamming;
- Low pull, high release. Energisation status indicator light, release status LED is off;
- VCC for the system power, JD_VCC for the relay power. Default hair 12V relay, plug the jumper cap to;
- Relay Maximum output : DC 30V/10A, AC 250V/10A
- Wiring : VCC : positive power supply system GND : System power supply negative IN1 ? IN4 : relay control ports
- Add to cart
- Decade counter/decimal decode display (CD4017B)
- Binary counter/decoder
- Frequency division
- Counter control/timers
- Divde-by-N counting
- For further application information, see ICAN-6166 “COS/MOS MSI Counter and Register Design and Applications”
Akshay (verified owner) –
Very fast delivery.