TIP127 PNP Power Darlington Transistor 100V 5A TO-220 Package
₹7.54 + GST
Specifications:-
| Transistor Polarity | PNP |
| Collector?Emitter Voltage (VCEO) | 100V |
| Collector?Base Voltage (VCBO) | 100V |
| Continuous Collector Current (Ic) | 5A |
| Continuous Base Current (Ib) | 0.12A |
| Emitter Base Voltage (VEBO) | 5V |
| Power Dissipation (Pd) | 65W |
| Operating Temperature Range | -65 – 150?C |
| DC Current Gain (hFE) | 1000 |
34 in stock
TIP127 is a three layer PNP device within the working range, the collector current IC is a function of the base current IB, a change in the base current giving a corresponding amplified change in the collector current for a given collector emitter voltage VCE.
Features:-
? Low saturation voltage
? Simple drive requirements
? High safe operating area
? For low distortion complementary designs
? Easy to carry and handle
You must be logged in to post a review.
Related products
- Add to cart
Specification
- This relay module is 5 Volts active low.
- It is an 8-channel relay interface board, which can be controlled directly by a wide range of microcontrollers such as Arduino, AVR, PIC, ARM, PLC, etc.
- It is also able to control various appliances and other equipments with large current.
- Relay output maximum contact is AC250V 10A and DC30V 10A.
- Standard interface can be directly connected with microcontrollers.
- Red working status indicator lights are conducive to the safe use.
- Widely used for all MCU control, industrial sector, PLC control, smart home control.
- Input port IN1, IN2, IN3, IN4, IN5, IN6, IN7, IN8 low signal level effectively.
- VCC, GND : Input power.
- JD – VCC : Relay power input port,relay can power alone.
- Working voltage : 5V
- Module weight : about 112g
- package weight : about 150g
- module size : about 1.7cm X 5.5cm X 13.7cm(height * width * long)
Quartz Crystal Oscillator 16MHz HC-49S 2 Pin for TV, car Electronics, PC Card, Electronic Watch, DVD, MP3v
₹6.72 + GSTAdd to cartCrystal Oscillators are used as a quick and easy way to offer circuits a very accurate and consistent frequency output. This 16 MHz Crystal is a thru-hole type and is typically used with microcontrollers.- Add to cart
Relays are output devices which are used to control or operate some external devices.? This is a 5 volt Isolated relay module which means that there is a optocoupler used in between your control circuit and the relay thus protecting your circuit in case of any short circuit issues on the relay side.
1N4148 -100V ,450mA | Diode Small Signal
₹0.90 + GSTAdd to cartIt is one of the most popular and long lived switching diodes because of its dependable specifications and low cost. The 1N4148 is useful in switching applications up to about 100 MHz. The 1N4148 comes in a DO-35 glass package for thru-hole mounting.
- Add to cart
- Decade counter/decimal decode display (CD4017B)
- Binary counter/decoder
- Frequency division
- Counter control/timers
- Divde-by-N counting
- For further application information, see ICAN-6166 “COS/MOS MSI Counter and Register Design and Applications”
Reviews
There are no reviews yet.