TIP122 – 100V ,5A Darlington NPN Transistor
₹8.20 + GST
Specification
- Collector-Emitter-voltage B open VCE0: 100 V
- Collector-Base-voltage E open VCB0: 100 V
- Emitter-Base-voltage C open VEB0: 5 V
- Collector current IC: 5 A
- Peak Collector current ICM: 8 A
- Base current (dc) IB: 120 mA
- Junction temperature Tj?: – 65 + 150?C
- Storage temperature TS: – 65 + 150?C
- Recommended complementary PNP transistors TIP125, TIP126, TIP127
56 in stock
- TIP122 is a Darlington NPN Transistors. It is available in?TO220AB Plastic case in package with collector current 5 Ampere.
You must be logged in to post a review.
Related products
- Add to cart
2N2222 is NPN BJT?normally used in low power amplifiers and also for switching application.
2n2222 is used as a?small signal transistor?and used as a general purpose transistor and is very popular. ?This is in TO-92 package form.
Original Flex sensor 2.2 inches for Motion and Diy
₹276.73 + GSTAdd to cartFlex sensors are usually available in two sizes. One is 2.2 inch and another is 4.5 inch. Although the sizes are different the basic function remains the same. They are also divided based on resistance. There are LOW resistance, MEDIUM resistance and HIGH resistance types. Choose the appropriate type depending on requirement. ?Here we are going to discuss 2.2inch Flex sensor that is FS-L-0055.
- Add to cart
Relays are output devices which are used to control or operate some external devices.? This is a 5 volt Isolated relay module which means that there is a optocoupler used in between your control circuit and the relay thus protecting your circuit in case of any short circuit issues on the relay side.
- Add to cart
- Decade counter/decimal decode display (CD4017B)
- Binary counter/decoder
- Frequency division
- Counter control/timers
- Divde-by-N counting
- For further application information, see ICAN-6166 “COS/MOS MSI Counter and Register Design and Applications”
- Add to cart
Specification
- Size : 75mm (length) x 55mm (W) x 19.3mm (height);
- Weight : 80g;
- PCB Color : Blue;
- board four weeks with four screw holes, hole diameter 3.1mm, easy to install and fixed;
- Relay selection of quality loose music relays, SPDT. A common terminal, a normally open, one normally closed terminal;
- optocoupler isolation, good anti-jamming;
- Low pull, high release. Energisation status indicator light, release status LED is off;
- VCC for the system power, JD_VCC for the relay power. Default hair 12V relay, plug the jumper cap to;
- Relay Maximum output : DC 30V/10A, AC 250V/10A
- Wiring : VCC : positive power supply system GND : System power supply negative IN1 ? IN4 : relay control ports
Reviews
There are no reviews yet.