1k Single Turn Potentiometer
₹15.00 ₹8.20 + GST
A potentiometer is a manually adjustable variable resistor with 3 terminals.The most common form of potmeter is the single turn rotary potmeter.
42 in stock
Purchase & earn 8 SmartX Rewards Coin!A potentiometer is a manually adjustable variable resistor with 3 terminals.The most common form of potmeter is the single turn rotary potmeter.
13 reviews for 1k Single Turn Potentiometer
You must be logged in to post a review.
Related products
- Purchase & earn 1 SmartX Rewards Coins!Add to cartBuy now
BC557 is a widely used PNP bipolar junction transistor manufactured in small TO-92 package. It is a general purpose PNP transistor that can be used as a switch or amplifier in electronic circuits. Its HFE ratings are 125 to 800 which makes it an ideal transistor to use as a small signal amplifier in electronic circuits for example for audio signal amplification or other, the HFE ratings of BC557 can be determined by the last letter after its number for example BC557A HFE ratings are 110-220, BC557B HFE ratings are 200-450 and BC557C HFE ratings are 420-800. The max collector dissipation is 500 milliwatt which is also an another good point to use it in amplification stages. Moreover it will also perform well when used it as a switch for load under 100mA. The transistor has also good collector to emitter (VCE) value that is -45V, therefore you can easily use it in circuits using 40 to 45 volts DC.
- Purchase & earn 277 SmartX Rewards Coin!Add to cartBuy now
Flex sensors are usually available in two sizes. One is 2.2 inch and another is 4.5 inch. Although the sizes are different the basic function remains the same. They are also divided based on resistance. There are LOW resistance, MEDIUM resistance and HIGH resistance types. Choose the appropriate type depending on requirement. ?Here we are going to discuss 2.2inch Flex sensor that is FS-L-0055.
- Rated 4.67 out of 5
DHT11 Module Temperature and Humidity sensor Module for boards compatible with Arduino, ARM and other MCU
₹120.00₹65.00 + GSTPurchase & earn 65 SmartX Rewards Coin!Add to cartBuy nowThe DHT11 is a commonly used Temperature and humidity sensor. The sensor comes with a dedicated NTC to measure temperature and an 8-bit microcontroller to output the values of temperature and humidity as serial data. The sensor is also factory calibrated and hence easy to interface with other microcontrollers.
- Rated 4.17 out of 5
Single Channel 5v Relay Module with Isolation High Low Level Trigger
₹40.00₹39.00 + GSTPurchase & earn 39 SmartX Rewards Coin!Add to cartBuy nowRelays are output devices which are used to control or operate some external devices.? This is a 5 volt Isolated relay module which means that there is a optocoupler used in between your control circuit and the relay thus protecting your circuit in case of any short circuit issues on the relay side.
- Purchase & earn 15 SmartX Rewards Coin!Add to cartBuy now
This DC Voltage Sensor Module is essentially a 5:1 potential divider circuit built using precession resistors for high accuracy.
The Arduino analog input is limited to a 5 VDC input.? If you wish to measure higher voltages,this module allows you to measure voltages of 0-25V. Keep in mind, you are restricted to voltages that are less than 25 volts. More than that and you will exceed the voltage limit of your Arduino input.
Mayur (verified owner) –
Good support and recommended
Paaji (verified owner) –
Best cost electronic components in India
Prakash (verified owner) –
Very well worth the money.
Viral (verified owner) –
Very fast delivery.
Ketan (verified owner) –
Good techinical knowledge
Paaji (verified owner) –
The product is firmly packed.
Zohar (verified owner) –
Drone parts i ordered and found ok
Mayur (verified owner) –
I got my project done with these components Great Support
Prakash (verified owner) –
Good quality.
Ketan (verified owner) –
Very fast delivery.
Sneha (verified owner) –
Very well worth the money.
Devendra (verified owner) –
Good quality.
Rohit (verified owner) –
Very fast delivery.