0.22 ohm Resistor – 5 Watt
₹10.00
A resistor is a passive two-terminal electrical component that implements electrical resistance as a circuit element. In electronic circuits, resistors are used to reduce current flow, adjust signal levels, to divide voltages, bias active elements, and terminate transmission lines, among other uses.
(Note: Product Images are shown for illustrative purposes only and may differ from actual product.)
168 in stock
168 in stock
A resistor is a passive two-terminal electrical component that implements electrical resistance as a circuit element. In electronic circuits, resistors are used to reduce current flow, adjust signal levels, to divide voltages, bias active elements, and terminate transmission lines, among other uses.
(Note: Product Images are shown for illustrative purposes only and may differ from actual product.)
1 review for 0.22 ohm Resistor – 5 Watt
Related products
Add to cartSpecification
- Size : 75mm (length) x 55mm (W) x 19.3mm (height);
- Weight : 80g;
- PCB Color : Blue;
- board four weeks with four screw holes, hole diameter 3.1mm, easy to install and fixed;
- Relay selection of quality loose music relays, SPDT. A common terminal, a normally open, one normally closed terminal;
- optocoupler isolation, good anti-jamming;
- Low pull, high release. Energisation status indicator light, release status LED is off;
- VCC for the system power, JD_VCC for the relay power. Default hair 12V relay, plug the jumper cap to;
- Relay Maximum output : DC 30V/10A, AC 250V/10A
- Wiring : VCC : positive power supply system GND : System power supply negative IN1 – IN4 : relay control ports
Add to cartThe 74HC595 consists of an 8−bit shift register and an 8−bit D−typelatch with three−state parallel outputs. The shift register accepts serialdata and provides a serial output. The shift register also providesparallel data to the 8−bit latch. The shift register and latch haveindependent clock inputs. This device also has an asynchronous resetfor the shift register.The HC595 directly interfaces with the SPI serial data port onCMOS MPUs and MCUs
- Add to cart
This is a 100 x 2.5 mm Nylon cable tie also known as hose tie or Zip tie. The cable tie is perfect for holding items together specially electric cables or wires. The flexible design of the cable tie makes it easier to slip the ties under and around wire harness. Thanks to the teeth on one of the side of the belt makes it easier for self locking and securing the wires.
- Add to cart
Relays are output devices which are used to control or operate some external devices. This is a 5 volt Isolated relay module which means that there is a optocoupler used in between your control circuit and the relay thus protecting your circuit in case of any short circuit issues on the relay side.
- Add to cartCrystal Oscillators are used as a quick and easy way to offer circuits a very accurate and consistent frequency output. This 16 MHz Crystal is a thru-hole type and is typically used with microcontrollers.
Priya (verified owner) –
Very fast delivery.