NRF24L01 2.4GHz Wireless Transceiver Module
Original price was: ₹100.00.₹50.02Current price is: ₹50.02. + GST
- Has on board antenna. The nRF24L01 is a single chip 2.4GHz transceiver with an embedded baseband protocol engine (Enhanced ShockBurst), designed for ultra low power wireless applications.
- The nRF24L01 is designed for operation in the world wide ISM frequency band at 2.400 – 2.4835GHz. An MCU (microcontroller) and very few external passive components are needed to design a radio system with the nRF24L01. The nRF24L01 is configured and operated through a Serial Peripheral Interface (SPI.) Through this interface the register map is available. The register map contains all configuration registers in the nRF24L01 and is accessible in all operation modes of the chip.
- The embedded baseband protocol engine (Enhanced ShockBurst) is based on packet communication and supports various modes from manual operation to advanced autonomous protocol operation. Internal FIFOs ensure a smooth data flow between the radio front end and the systems MCU. Enhanced ShockBurst reduces system cost by handling all the high-speed link layer operations. The radio front end uses GFSK modulation. It has user configurable parameters like frequency channel, output power and air data rate.
- DNA Solutions has large collection of various types of Transceiver Module. Check our complete collection of Transceiver Module
Perfect for use in various electronics projects in India, NRF24L01 2.4GHz Wireless Transceiver Module ensures reliability and performance. Ideal for various electronics projects, NRF24L01 2.4GHz Wireless Transceiver Module offers quality and performance.
8 in stock
Specification
- NRF24L01 is a universal ISM band monolithic transceiver chip works in the 2.4-2.5GHz
- Wireless transceiver including : Frequency generator, enhanced type, SchockBurstTM, mode controller, power amplifier, crystal amplifier, modulator, demodulator
- The output power channel selection and protocol settings can be set extremely low current consumption, through the SPI interface
- As the transmit mode, the transmit power is 6dBm, the current is 9.0mA, the accepted mode current is 12.3mA, the current consumption of the power-down mode and standby mode are lower
- Built-in 2.4GHz antenna, supports up to six channels of data reception
- Size: 15 x 29mm (including antenna)
- Low operating voltage : 1.9-3.6V
- 125 channels, multi-point communication and frequency hopping to meet the communication needs
- High Rate : 2Mbps, as air transmission time is very short, greatly reducing collision phenomena in wireless transmission (air transfer rate of software setting: 1Mbps or 2Mbps)
- Low power consumption : When the answer mode communication, fast air transmission and start-up time, which greatly reduces the current consumption
- Low application cost : NRF24L01 integrated part of all high-speed signal processing related to RF protocol, such as: automatic retransmission of lost packets and automatically generate response signals, etc.
- NRF24L01 SPI interface : hardware SPI port, MCU I/O ports
- Internal FIFO compatible with a variety of microprocessor interface, micro-controller is convenient
Key Applications: Used widely in electronic circuits, automation, robotics, and educational projects. Optimized for reliable performance in India-specific environments and conditions.
Keywords: NRF24L01 2.4GHz Wireless Transceiver Module, electronic components India, NRF24L01 2.4GHz Wireless Transceiver Module buy online, electronic supplies India, NRF24L01 2.4GHz Wireless Transceiver Module price.
Applications: Suitable for electronics projects, automation, and educational purposes. Widely used in Indian and international markets.
Keywords: NRF24L01 2.4GHz Wireless Transceiver Module, buy NRF24L01 2.4GHz Wireless Transceiver Module online, electronics components, NRF24L01 2.4GHz Wireless Transceiver Module features, NRF24L01 2.4GHz Wireless Transceiver Module applications, high quality NRF24L01 2.4GHz Wireless Transceiver Module
2 reviews for NRF24L01 2.4GHz Wireless Transceiver Module
You must be logged in to post a review.
Related products
-
ESP-12F ESP8266 WIFI Module
Original price was: ₹130.00.₹97.00Current price is: ₹97.00. + GSTAdd to cartCore processor ESP8266 in smaller sizes of the module encapsulates Tensilica L106 integrates industry-leading ultra low power 32-bit MCU micro, with the 16-bit short mode, Clock speed support 80 MHz, 160 MHz, supports the RTOS, integrated Wi Fi MAC/BB/RF/PA/LNA, on-board antenna.Perfect for use in various electronics projects in India, Quality ESP-12F ESP8266 Remote Serial Port WIFI Transceiver Wireless Module ensures reliability and performance. Ideal for various electronics projects, Quality ESP-12F ESP8266 Remote Serial Port WIFI Transceiver Wireless Module offers quality and performance.
-
BC327 PNP General Purpose Amplifier Transistor
Original price was: ₹5.00.₹1.95Current price is: ₹1.95. + GSTAdd to cartBC327 is a general purpose PNP BJP transistor that can be used for switching and amplification purposes in electronic circuits. The transistor features 800mA collector current hence it can be used to drive variety of loads in an electronic application. The max collector-emitter voltage is -45V therefore it can easily handle load voltage under 45V. Apart from that transistor also features 625mW collector dissipation and DC current gain of maximum 630 therefore it can also be used as an audio amplifier or for any type of signal amplification.
-
8 Channel 5V Relay Board Expansion Module Optocoupler compatible UNO Raspberry
Original price was: ₹312.00.₹246.16Current price is: ₹246.16. + GSTAdd to cartSpecification
- This relay module is 5 Volts active low.
- It is an 8-channel relay interface board, which can be controlled directly by a wide range of microcontrollers such as Arduino, AVR, PIC, ARM, PLC, etc.
- It is also able to control various appliances and other equipments with large current.
- Relay output maximum contact is AC250V 10A and DC30V 10A.
- Standard interface can be directly connected with microcontrollers.
- Red working status indicator lights are conducive to the safe use.
- Widely used for all MCU control, industrial sector, PLC control, smart home control.
- Input port IN1, IN2, IN3, IN4, IN5, IN6, IN7, IN8 low signal level effectively.
- VCC, GND : Input power.
- JD – VCC : Relay power input port,relay can power alone.
- Working voltage : 5V
- Module weight : about 112g
- package weight : about 150g
- module size : about 1.7cm X 5.5cm X 13.7cm(height * width * long)
Perfect for use in various electronics projects in India, 8 Channel 5V Relay Board Expansion Module Optocoupler compatible UNO Raspberry ensures reliability and performance. Ideal for various electronics projects, 8 Channel 5V Relay Board Expansion Module Optocoupler compatible UNO Raspberry offers quality and performance.
-
Original Flex sensor 2.2 inches for Motion and Diy
Original price was: ₹400.00.₹222.00Current price is: ₹222.00. + GSTAdd to cartFlex sensors are usually available in two sizes. One is 2.2 inch and another is 4.5 inch. Although the sizes are different the basic function remains the same. They are also divided based on resistance. There are LOW resistance, MEDIUM resistance and HIGH resistance types. Choose the appropriate type depending on requirement. Here we are going to discuss 2.2inch Flex sensor that is FS-L-0055. Perfect for use in various electronics projects in India, Original Flex sensor 2.2 inches for Motion and Diy ensures reliability and performance. Ideal for various electronics projects, Original Flex sensor 2.2 inches for Motion and Diy offers quality and performance.
-
BC557 PNP General Purpose Transistor 45V 100mA TO-92 Package
Original price was: ₹5.00.₹1.17Current price is: ₹1.17. + GSTAdd to cartBC557 is a widely used PNP bipolar junction transistor manufactured in small TO-92 package. It is a general purpose PNP transistor that can be used as a switch or amplifier in electronic circuits. Its HFE ratings are 125 to 800 which makes it an ideal transistor to use as a small signal amplifier in electronic circuits for example for audio signal amplification or other, the HFE ratings of BC557 can be determined by the last letter after its number for example BC557A HFE ratings are 110-220, BC557B HFE ratings are 200-450 and BC557C HFE ratings are 420-800. The max collector dissipation is 500 milliwatt which is also an another good point to use it in amplification stages. Moreover it will also perform well when used it as a switch for load under 100mA. The transistor has also good collector to emitter (VCE) value that is -45V, therefore you can easily use it in circuits using 40 to 45 volts DC.
Zohar (verified owner) –
Good support and recommended
Ayush (verified owner) –
Best cost electronic components in India