ISD1820 Voice Record Module
Original price was: ₹200.00.₹131.00Current price is: ₹131.00. + GST
- It can offers true single?chip voice recording, no?volatile storage, and playback capability for 8 to 20 seconds. The sample is 3.2k and the total 20s for the Recorder. This module use is very easy which you could direct control by push button on board or by Microcontroller such as Arduino, STM32, ChipKit etc. From these, you can easy control record , playback and repeat and so on.
- We have Various sizes of Audio, Sound and Voice Module. Check out our complete collection of Audio, Sound and Voice Module.
2 in stock
Specification
- Push?button interface, playback can be edge or level activated
- Automatic power?dwon mode
- On?chip 8? speaker driver
- Signal 3V Power Supply
- Can be controlled both manually or by MCU
- Sample rate and duration changable by replacing a single resistor
- Record up to 20 seconds of audio
- Dimensions : 37 x 54 mm
13 reviews for ISD1820 Voice Record Module
You must be logged in to post a review.
Related products
-
Quartz Crystal Oscillator 16MHz HC-49S 2 Pin for TV, car Electronics, PC Card, Electronic Watch, DVD, MP3v
Original price was: ₹15.00.₹6.72Current price is: ₹6.72. + GSTAdd to cartCrystal Oscillators are used as a quick and easy way to offer circuits a very accurate and consistent frequency output. This 16 MHz Crystal is a thru-hole type and is typically used with microcontrollers. -
DHT11 Module Temperature and Humidity sensor Module for boards compatible with Arduino, ARM and other MCU
Original price was: ₹120.00.₹65.00Current price is: ₹65.00. + GSTAdd to cartThe DHT11 is a commonly used Temperature and humidity sensor. The sensor comes with a dedicated NTC to measure temperature and an 8-bit microcontroller to output the values of temperature and humidity as serial data. The sensor is also factory calibrated and hence easy to interface with other microcontrollers.
-
5.5mm x 2.1mm 3 Pin Female DC Power Jack Panel Mount Screw Nut Kit DC Socket Electrical Plug
Original price was: ₹20.00.₹8.20Current price is: ₹8.20. + GSTAdd to cart- Widely used in small-scale as well as prototyping projects where 12 to 30 volts power supply needed
- Supports DC Power Jack: 2.1 x 5.5 mm
- Diameter: 14mm
-
100 MM x 2.5 MM, Nylon Zip Wire Organizer/Self Locking
Original price was: ₹10.00.₹1.64Current price is: ₹1.64. + GSTAdd to cartThis is a?100 x 2.5 mm Nylon cable tie?also known as hose tie or Zip tie. The?cable tie?is perfect for holding items together specially electric cables or wires.? The flexible design of the?cable tie?makes it easier to slip the ties under and around wire harness. Thanks to the teeth on one of the side of the belt makes it easier for self locking and securing the wires.
-
Voltage Sensor Module 25VDC
Original price was: ₹16.00.₹15.08Current price is: ₹15.08. + GSTAdd to cartThis DC Voltage Sensor Module is essentially a 5:1 potential divider circuit built using precession resistors for high accuracy.
The Arduino analog input is limited to a 5 VDC input.? If you wish to measure higher voltages,this module allows you to measure voltages of 0-25V. Keep in mind, you are restricted to voltages that are less than 25 volts. More than that and you will exceed the voltage limit of your Arduino input.
Vikas (verified owner) –
I got my project done with these components Great Support
Jayen (verified owner) –
Good support and recommended
Jayen (verified owner) –
Good techinical knowledge
Prakash (verified owner) –
The product is firmly packed.
Shubham (verified owner) –
Good techinical knowledge
Mayur (verified owner) –
Good quality.
Komal (verified owner) –
Good techinical knowledge
Shubham (verified owner) –
Less cost than other websites
Harsh (verified owner) –
Good techinical knowledge
Viral (verified owner) –
Online best cost electronic components
Roma (verified owner) –
Good support and recommended
Rahul (verified owner) –
Good support and recommended
Ketan (verified owner) –
Good support and recommended