E27 PIR Infrared Motion Sensor LED Lamp Holder Control Switch, Multicolored (BE0364)
Original price was: ₹679.00.₹480.00Current price is: ₹480.00. + GST
3 in stock
Features
- Voltage: AC 170-250V, 50/60Hz. Load power: 3-80W.
- Sensing range: 5-8M 110?. Sensitivity: 5LUX. Delay time: 15~30seconds.
- Infrared Sensor Automatic Lighting Control Switch with lamp holder; convenient, safe & practical.
- Good solution for energy saving. Easy to Install.
- You can conveniently to let the light auto on/off .The switch can detect human body’s infrared , and use infrared to control the load.
You must be logged in to post a review.
Related products
-
BC557 PNP General Purpose Transistor 45V 100mA TO-92 Package
Original price was: ₹5.00.₹1.17Current price is: ₹1.17. + GSTAdd to cartBC557 is a widely used PNP bipolar junction transistor manufactured in small TO-92 package. It is a general purpose PNP transistor that can be used as a switch or amplifier in electronic circuits. Its HFE ratings are 125 to 800 which makes it an ideal transistor to use as a small signal amplifier in electronic circuits for example for audio signal amplification or other, the HFE ratings of BC557 can be determined by the last letter after its number for example BC557A HFE ratings are 110-220, BC557B HFE ratings are 200-450 and BC557C HFE ratings are 420-800. The max collector dissipation is 500 milliwatt which is also an another good point to use it in amplification stages. Moreover it will also perform well when used it as a switch for load under 100mA. The transistor has also good collector to emitter (VCE) value that is -45V, therefore you can easily use it in circuits using 40 to 45 volts DC.
-
100 MM x 2.5 MM, Nylon Zip Wire Organizer/Self Locking
Original price was: ₹10.00.₹1.64Current price is: ₹1.64. + GSTAdd to cartThis is a?100 x 2.5 mm Nylon cable tie?also known as hose tie or Zip tie. The?cable tie?is perfect for holding items together specially electric cables or wires.? The flexible design of the?cable tie?makes it easier to slip the ties under and around wire harness. Thanks to the teeth on one of the side of the belt makes it easier for self locking and securing the wires.
-
Crystal Oscillator 8 MHZ
Original price was: ₹15.00.₹6.72Current price is: ₹6.72. + GSTAdd to cartThis is a 8MHZ Crystal. This is a low cost crystal oscillator with?oscillation frequency of 8Mhz. Crystal are normally required to provide?clock pulses to your micro controller or other IC’s which require external clock?source.
An oscillator crystal has two electrically conductive plates, with a slice or?tuning fork of quartz crystal sandwiched between them. The crystal oscillator?circuit sustains oscillation by taking a voltage signal from the quartz?resonator, amplifying it, and feeding it back to the resonator. Quartz has the?further advantage that its elastic constants and its size change in such a way?that the frequency dependence on temperature can be very low.
-
Single Channel 5v Relay Module High Low Level Trigger
Original price was: ₹40.00.₹39.00Current price is: ₹39.00. + GSTAdd to cartRelays are output devices which are used to control or operate some external devices.? This is a 5 volt Isolated relay module which means that there is a optocoupler used in between your control circuit and the relay thus protecting your circuit in case of any short circuit issues on the relay side.
-
DHT11 Module Temperature and Humidity sensor Module for boards compatible with Arduino, ARM and other MCU
Original price was: ₹120.00.₹65.00Current price is: ₹65.00. + GSTAdd to cartThe DHT11 is a commonly used Temperature and humidity sensor. The sensor comes with a dedicated NTC to measure temperature and an 8-bit microcontroller to output the values of temperature and humidity as serial data. The sensor is also factory calibrated and hence easy to interface with other microcontrollers.
Reviews
There are no reviews yet.