Dual USB 5V 1A 2.1A 18650 Battery Charger Module with LCD Display
₹182.39 + GST
- Micro USB input: 5 V 1A
- USB output: 5V 2.1A / 5V 1A (Dual USB interface)
- Charging screen: intelligent digital screen
- Type of batteries: liquid lithium ion batteries (18650)
- Product size: 57mm x 28mm
- Screen size: 27mm x 17mm
- Input Voltage: 3.7V
- The circuit board is connected to the negative battery B-, B is positive
- Check polarity, wrong wiring will burn the board.
- the battery is connected in parallel welding.
- There is insulation between the battery and the circuit board
- The battery can not touch the circuit board, may cause short circuit if it does.
4 in stock
- Dual USB Charging Control Board for mobile power banks. The LCD Display module provides charge status.?The module?provides?overload protection,?over-discharge protection and?overcurrent protection.
You must be logged in to post a review.
Related products
BC547 NPN General Purpose Transistor
₹0.98 + GSTAdd to cartBC547 is a general purpose BJT NPN transistor mostly used in electronics hobbyists and educational electronics projects. Besides these uses it can also be used in commercial circuits. It comes in TO-92 packaging and the maximum output current this transistor can handle is 100mA. The transistor is having very good DC current gain and low noise capabilities due to which it is ideal to use in signal amplification stages. The typical saturation voltage is only 90 millivolts which is also a good sign to use it as a switch.
1N4148 -100V ,450mA | Diode Small Signal
₹0.90 + GSTAdd to cartIt is one of the most popular and long lived switching diodes because of its dependable specifications and low cost. The 1N4148 is useful in switching applications up to about 100 MHz. The 1N4148 comes in a DO-35 glass package for thru-hole mounting.
- Add to cart
The 74HC595 consists of an 8?bit shift register and an 8?bit D?typelatch with three?state parallel outputs. The shift register accepts serialdata and provides a serial output. The shift register also providesparallel data to the 8?bit latch. The shift register and latch haveindependent clock inputs. This device also has an asynchronous resetfor the shift register.The HC595 directly interfaces with the SPI serial data port onCMOS MPUs and MCUs
Crystal Oscillator 8 MHZ
₹6.72 + GSTAdd to cartThis is a 8MHZ Crystal. This is a low cost crystal oscillator with?oscillation frequency of 8Mhz. Crystal are normally required to provide?clock pulses to your micro controller or other IC’s which require external clock?source.
An oscillator crystal has two electrically conductive plates, with a slice or?tuning fork of quartz crystal sandwiched between them. The crystal oscillator?circuit sustains oscillation by taking a voltage signal from the quartz?resonator, amplifying it, and feeding it back to the resonator. Quartz has the?further advantage that its elastic constants and its size change in such a way?that the frequency dependence on temperature can be very low.
- Add to cart
BC557 is a widely used PNP bipolar junction transistor manufactured in small TO-92 package. It is a general purpose PNP transistor that can be used as a switch or amplifier in electronic circuits. Its HFE ratings are 125 to 800 which makes it an ideal transistor to use as a small signal amplifier in electronic circuits for example for audio signal amplification or other, the HFE ratings of BC557 can be determined by the last letter after its number for example BC557A HFE ratings are 110-220, BC557B HFE ratings are 200-450 and BC557C HFE ratings are 420-800. The max collector dissipation is 500 milliwatt which is also an another good point to use it in amplification stages. Moreover it will also perform well when used it as a switch for load under 100mA. The transistor has also good collector to emitter (VCE) value that is -45V, therefore you can easily use it in circuits using 40 to 45 volts DC.
Reviews
There are no reviews yet.