PCB Mount 3 Pin DC Female Power Jack Connector Socket
₹8.12 + GST
Specification
- Conditions of Use : Operating temperature range: -40-55?C
- Rated Load : DC 30V 0.5A
- Contact resistance : ?0.03 ?
- Insulation resistance : ?100M? DC 250V
- Withstand Voltage : AC 500V (50Hz) / min
- Insertion force : 3-20N
- Life : 5000 times
- Size : 2.1 X 5.5 mm
435 in stock
- This is a common barrel-type power jack for DC power. These are compatible with our DC wall supplies and have a 5.5mm jack, with a 2.1mm center pole diameter.
- This DC Power PCB Mounting Socket is the same one that is used in your Arduino Uno Board. So if you want to reduce all power wiring on your PCB then provide this power socket mounting option on your PCB.
1 review for PCB Mount 3 Pin DC Female Power Jack Connector Socket
You must be logged in to post a review.
Related products
Voltage Sensor Module 25VDC
₹50.12 + GSTAdd to cartThis DC Voltage Sensor Module is essentially a 5:1 potential divider circuit built using precession resistors for high accuracy.
The Arduino analog input is limited to a 5 VDC input.? If you wish to measure higher voltages,this module allows you to measure voltages of 0-25V. Keep in mind, you are restricted to voltages that are less than 25 volts. More than that and you will exceed the voltage limit of your Arduino input.
DHT11 Module Temperature and Humidity sensor Module for boards compatible with Arduino, ARM and other MCU
₹88.05 + GSTAdd to cartThe DHT11 is a commonly used Temperature and humidity sensor. The sensor comes with a dedicated NTC to measure temperature and an 8-bit microcontroller to output the values of temperature and humidity as serial data. The sensor is also factory calibrated and hence easy to interface with other microcontrollers.
Quartz Crystal Oscillator 16MHz HC-49S 2 Pin for TV, car Electronics, PC Card, Electronic Watch, DVD, MP3v
₹6.72 + GSTAdd to cartCrystal Oscillators are used as a quick and easy way to offer circuits a very accurate and consistent frequency output. This 16 MHz Crystal is a thru-hole type and is typically used with microcontrollers.- Add to cart
- Decade counter/decimal decode display (CD4017B)
- Binary counter/decoder
- Frequency division
- Counter control/timers
- Divde-by-N counting
- For further application information, see ICAN-6166 “COS/MOS MSI Counter and Register Design and Applications”
- Add to cart
Relays are output devices which are used to control or operate some external devices.? This is a 5 volt Isolated relay module which means that there is a optocoupler used in between your control circuit and the relay thus protecting your circuit in case of any short circuit issues on the relay side.
Ketan (verified owner) –
Good service.