ESP-12E: ESP8266 Serial Port WIFI Wireless Transceiver Module For Arduino
Original price was: ₹107.00.₹104.52Current price is: ₹104.52. + GST
Features :
- WS2812 Led on board.
- 802.11 b/g/n
- Wi-Fi Direct (P2P), soft-AP
- Integrated TCP/IP protocol stack
- Integrated TR switch, balun, LNA, power amplifier and matching network
- Integrated PLL, regulators, DCXO and power management units
- +19.5dBm output power in 802.11b mode
- Power down leakage current of <10uA
- Integrated low power 32-bit CPU could be used as an application processor
- SDIO 1.1 / 2.0, SPI, UART
- STBC, 1?1 MIMO, 2?1 MIMO
- A-MPDU & A-MSDU aggregation & 0.4ms guard interval
- Wake up and transmit packets in < 2ms
- Standby power consumption of < 1.0mW (DTIM3)
- Access Point and Station Modes.
8 in stock
- This is?ESP-12E: ESP8266 Serial Port WIFI Wireless Transceiver Module For Arduino.
- This small WIFI?transceiver is the perfect solution for home Automation and IoT applications. It can be the replacement of your NRF24L01, it can talk to your WIFI router directly through the UART MCU?s (Rx, Tx).
- The ESP-12 module is one of the most complete of the ESP family as it allows you to use the biggest amount of pins of all of them. You can program this module to work stand alone with the Arduino IDE or with LUA as NodeMCU.
- The system is equipped with ESP8266 manifested leading features are: energy saving VoIP quickly switch between the sleep/wake patterns, with low-power operation adaptive radio bias, front-end signal processing functions.
- The ESP8266-03 is one of the smallest versions of this module. It includes a built-in ceramic antenna.
20 reviews for ESP-12E: ESP8266 Serial Port WIFI Wireless Transceiver Module For Arduino
You must be logged in to post a review.
Related products
-
5V Low Level Solid State Relay Module with Fuse SSR 250V 2A Fuse
Original price was: ₹150.00.₹110.00Current price is: ₹110.00. + GSTAdd to cart1-Channel?Solid-State Relay is some what similar to that of a mechanical relay & the difference is that, there is no moving contact in a Solid-State Relay. Here we make use of Phototropic coupler to turn it ON and OFF.
-
Voltage Sensor Module 25VDC
Original price was: ₹16.00.₹15.08Current price is: ₹15.08. + GSTAdd to cartThis DC Voltage Sensor Module is essentially a 5:1 potential divider circuit built using precession resistors for high accuracy.
The Arduino analog input is limited to a 5 VDC input.? If you wish to measure higher voltages,this module allows you to measure voltages of 0-25V. Keep in mind, you are restricted to voltages that are less than 25 volts. More than that and you will exceed the voltage limit of your Arduino input.
-
BC547 NPN General Purpose Transistor
Original price was: ₹5.00.₹1.17Current price is: ₹1.17. + GSTAdd to cartBC547 is a general purpose BJT NPN transistor mostly used in electronics hobbyists and educational electronics projects. Besides these uses it can also be used in commercial circuits. It comes in TO-92 packaging and the maximum output current this transistor can handle is 100mA. The transistor is having very good DC current gain and low noise capabilities due to which it is ideal to use in signal amplification stages. The typical saturation voltage is only 90 millivolts which is also a good sign to use it as a switch.
-
Crystal Oscillator 8 MHZ
Original price was: ₹15.00.₹6.72Current price is: ₹6.72. + GSTAdd to cartThis is a 8MHZ Crystal. This is a low cost crystal oscillator with?oscillation frequency of 8Mhz. Crystal are normally required to provide?clock pulses to your micro controller or other IC’s which require external clock?source.
An oscillator crystal has two electrically conductive plates, with a slice or?tuning fork of quartz crystal sandwiched between them. The crystal oscillator?circuit sustains oscillation by taking a voltage signal from the quartz?resonator, amplifying it, and feeding it back to the resonator. Quartz has the?further advantage that its elastic constants and its size change in such a way?that the frequency dependence on temperature can be very low.
-
Lcd 16X2 Yellow Backlight Alphanumeric Display for 8051,Avr,Arduino,Raspberry Pi,Pic,Arm All Microcontroller (Green)
Original price was: ₹112.00.₹91.82Current price is: ₹91.82. + GSTAdd to cart- Operating Voltage is 4.7V to 5.3V
- Current consumption is 1mA without backlight
- Alphanumeric LCD display module, meaning can display alphabets and numbers
- Consists of two rows and each row can print 16 characters.
- Each character is build by a 5?8 pixel box
- Can work on both 8-bit and 4-bit mode
- It can also display any custom generated characters
- Available in Green Backlight
Akshay (verified owner) –
Best cost electronic components in India
Jayen (verified owner) –
Best cost electronic components in India
Prakash (verified owner) –
The product is firmly packed.
Zohar (verified owner) –
Less cost than other websites
Prakash (verified owner) –
Online best cost electronic components
Vivek (verified owner) –
Good quality.
Prakash (verified owner) –
Very fast delivery.
Akshay (verified owner) –
I got my project done with these components Great Support
Viral (verified owner) –
I got my project done with these components Great Support
Zohar (verified owner) –
Less cost than other websites
Sneha (verified owner) –
Less cost than other websites
Komal (verified owner) –
Good service.
Devendra (verified owner) –
Less cost than other websites
Viral (verified owner) –
Good service.
Lokesh (verified owner) –
The product is firmly packed.
Vivek (verified owner) –
Online best cost electronic components
Rahul (verified owner) –
Good support and recommended
Jayen (verified owner) –
I got my project done with these components Great Support
Harsh (verified owner) –
Good quality.
Sneha (verified owner) –
I got my project done with these components Great Support