5MP Raspberry Pi 3/4 Model B Camera Module Rev 1.3 with Cable

• The Digital Multi Servo Tester ESC RC Consistency CCPM Master Speed Control offers 3 modes to check servos or ESC. The Manual Mode allows you to turn the knob to different speeds and check the reaction time. The Neutral mode makes the servo go back to the neutral point. The Automatic Window Wiper Mode makes the servo swing like a window wiper in the largest angle possible.
• Plus, this servo tester can connect to up to 3 servos simultaneously. You can also connect up to 3 ESCs to test and compare their reaction time respectively
• DNA Solutions has large collection of various types of Motor Driver Module. Check our complete collection of Motor Driver Modules.

• Has on board antenna. The nRF24L01 is a single chip 2.4GHz transceiver with an embedded baseband protocol engine (Enhanced ShockBurst), designed for ultra low power wireless applications.
• The nRF24L01 is designed for operation in the world wide ISM frequency band at 2.400 - 2.4835GHz. An MCU (microcontroller) and very few external passive components are needed to design a radio system with the nRF24L01. The nRF24L01 is configured and operated through a Serial Peripheral Interface (SPI.) Through this interface the register map is available. The register map contains all configuration registers in the nRF24L01 and is accessible in all operation modes of the chip.
• The embedded baseband protocol engine (Enhanced ShockBurst) is based on packet communication and supports various modes from manual operation to advanced autonomous protocol operation. Internal FIFOs ensure a smooth data flow between the radio front end and the systems MCU. Enhanced ShockBurst reduces system cost by handling all the high-speed link layer operations. The radio front end uses GFSK modulation. It has user configurable parameters like frequency channel, output power and air data rate.
• DNA Solutions has large collection of various types of Transceiver Module. Check our complete collection of Transceiver Module

• This is a complete GPS module that is based on the NEO 6M GPS. This unit uses the latest technology to give the best possible positioning information and includes a larger built-in 25 x 25mm active GPS antenna with a UART TTL socket. A battery is also included so that you can obtain a GPS lock faster. This is an updated GPS module that can be used with ardupilot mega v2. This GPS module gives the best possible position information, allowing for better performance with your Ardupilot or other Multirotor control platform.
• The GPS module has serial TTL output, it has four pins: TX, RX, VCC, and GND. You can download the u-centre software for configuring the GPS and changing the settings and much more. It is really good software (see link below).

Specification

• This relay module is 5 Volts active low.

• It is an 8-channel relay interface board, which can be controlled directly by a wide range of microcontrollers such as Arduino, AVR, PIC, ARM, PLC, etc.

• It is also able to control various appliances and other equipments with large current.

• Relay output maximum contact is AC250V 10A and DC30V 10A.

• Standard interface can be directly connected with microcontrollers.

• Red working status indicator lights are conducive to the safe use.

• Widely used for all MCU control, industrial sector, PLC control, smart home control.

• Input port IN1, IN2, IN3, IN4, IN5, IN6, IN7, IN8 low signal level effectively.

• VCC, GND : Input power.

• JD - VCC : Relay power input port,relay can power alone.

• Working voltage : 5V

• Module weight : about 112g

• package weight : about 150g

• module size : about 1.7cm X 5.5cm X 13.7cm(height * width * long)