Capacitor 2200uf 50v/63v Aluminium Electrolytic
Original price was: ₹40.00.₹25.06Current price is: ₹25.06. + GST
165 in stock
Specification
:?330?F
:?250V
:?LZ Series
:?? 20%
:?Quick Connect, Snap-In
:?2000 hours @ 105?C
:?Polar
:?22mm
11 reviews for Capacitor 2200uf 50v/63v Aluminium Electrolytic
You must be logged in to post a review.
Related products
-
3.7V 1200 mAh Li-ion Cylindrical Battery | 3.7V Lithium Ion Battery for DIY Projects | Lithium Ion Cylindrical Battery
Original price was: ₹60.00.₹44.03Current price is: ₹44.03. + GSTAdd to cartA lithium-ion battery or Li-ion battery is a type of rechargeable battery. Lithium-ion batteries are commonly used for portable electronics and electric vehicles and are growing in popularity for military and aerospace applications.
-
BC327 PNP General Purpose Amplifier Transistor
Original price was: ₹5.00.₹1.95Current price is: ₹1.95. + GSTAdd to cartBC327 is a general purpose PNP BJP transistor that can be used for switching and amplification purposes in electronic circuits. The transistor features 800mA collector current hence it can be used to drive variety of loads in an electronic application. The max collector-emitter voltage is -45V therefore it can easily handle load voltage under 45V. Apart from that transistor also features 625mW collector dissipation and DC current gain of maximum 630 therefore it can also be used as an audio amplifier or for any type of signal amplification.
-
Voltage Sensor Module 25VDC
Original price was: ₹16.00.₹15.08Current price is: ₹15.08. + GSTAdd to cartThis DC Voltage Sensor Module is essentially a 5:1 potential divider circuit built using precession resistors for high accuracy.
The Arduino analog input is limited to a 5 VDC input.? If you wish to measure higher voltages,this module allows you to measure voltages of 0-25V. Keep in mind, you are restricted to voltages that are less than 25 volts. More than that and you will exceed the voltage limit of your Arduino input.
-
5V Low Level Solid State Relay Module with Fuse SSR 250V 2A Fuse
Original price was: ₹150.00.₹110.00Current price is: ₹110.00. + GSTAdd to cart1-Channel?Solid-State Relay is some what similar to that of a mechanical relay & the difference is that, there is no moving contact in a Solid-State Relay. Here we make use of Phototropic coupler to turn it ON and OFF.
-
DHT11 Module Temperature and Humidity sensor Module for boards compatible with Arduino, ARM and other MCU
Original price was: ₹120.00.₹65.00Current price is: ₹65.00. + GSTAdd to cartThe DHT11 is a commonly used Temperature and humidity sensor. The sensor comes with a dedicated NTC to measure temperature and an 8-bit microcontroller to output the values of temperature and humidity as serial data. The sensor is also factory calibrated and hence easy to interface with other microcontrollers.
Viral (verified owner) –
Very well worth the money.
Priya (verified owner) –
Good service.
Prakash (verified owner) –
Less cost than other websites
Viral (verified owner) –
Good techinical knowledge
Mayur (verified owner) –
Drone parts i ordered and found ok
Harsh (verified owner) –
Drone parts i ordered and found ok
Vikas (verified owner) –
Good support and recommended
Harsh (verified owner) –
Less cost than other websites
Ketan (verified owner) –
Less cost than other websites
Er.Prashant (verified owner) –
Good techinical knowledge
Ayush (verified owner) –
Good support and recommended