

TL3842P – Current Mode PWM Controller, 12V-25V supply, 30V/200mA out, 100 kHz, DIP-8 IC
₹26.00 ₹18.87 + GST
Specification
Output Type -? Transistor Driver
Function – Step-Up, Step-Up/Step-Down
Output Configuration-? Positive
Voltage – Supply (Vcc/Vdd) – 10V ~ 30V
Frequency – Switching-? Up to 500kHz
Control Features-? Frequency Control
15 in stock
Purchase & earn 19 SmartX Rewards Coin!You must be logged in to post a review.
Related products
- Purchase & earn 7 SmartX Rewards Coin!Add to cart
This is a 8MHZ Crystal. This is a low cost crystal oscillator with?oscillation frequency of 8Mhz. Crystal are normally required to provide?clock pulses to your micro controller or other IC’s which require external clock?source.
An oscillator crystal has two electrically conductive plates, with a slice or?tuning fork of quartz crystal sandwiched between them. The crystal oscillator?circuit sustains oscillation by taking a voltage signal from the quartz?resonator, amplifying it, and feeding it back to the resonator. Quartz has the?further advantage that its elastic constants and its size change in such a way?that the frequency dependence on temperature can be very low.
- Purchase & earn 2 SmartX Rewards Coin!Add to cart
BC327 is a general purpose PNP BJP transistor that can be used for switching and amplification purposes in electronic circuits. The transistor features 800mA collector current hence it can be used to drive variety of loads in an electronic application. The max collector-emitter voltage is -45V therefore it can easily handle load voltage under 45V. Apart from that transistor also features 625mW collector dissipation and DC current gain of maximum 630 therefore it can also be used as an audio amplifier or for any type of signal amplification.
- Rated 4.48 out of 5
5.5mm x 2.1mm 3 Pin Female DC Power Jack Panel Mount Screw Nut Kit DC Socket Electrical Plug
₹20.00₹8.20 + GSTPurchase & earn 8 SmartX Rewards Coin!Add to cart- Widely used in small-scale as well as prototyping projects where 12 to 30 volts power supply needed
- Supports DC Power Jack: 2.1 x 5.5 mm
- Diameter: 14mm
- Purchase & earn 50 SmartX Rewards Coin!Add to cart
This DC Voltage Sensor Module is essentially a 5:1 potential divider circuit built using precession resistors for high accuracy.
The Arduino analog input is limited to a 5 VDC input.? If you wish to measure higher voltages,this module allows you to measure voltages of 0-25V. Keep in mind, you are restricted to voltages that are less than 25 volts. More than that and you will exceed the voltage limit of your Arduino input.
- Rated 4.58 out of 5
3.7V 1200 mAh Li-ion Cylindrical Battery | 3.7V Lithium Ion Battery for DIY Projects | Lithium Ion Cylindrical Battery
₹60.00₹44.03 + GSTPurchase & earn 44 SmartX Rewards Coin!Add to cartA lithium-ion battery or Li-ion battery is a type of rechargeable battery. Lithium-ion batteries are commonly used for portable electronics and electric vehicles and are growing in popularity for military and aerospace applications.
Reviews
There are no reviews yet.