Single Beam Infrared Sensor for Automatic Doors
₹464.12 + GST
Specifications :-
| Operating Voltage (VDC) | 12 ~ 24 |
| Operating Distance Range (Meter) | 20 |
| Wavelength (nm) | 940 |
| Operating Temperature (C) | -20 to 70 |
| Relay Capacity | [emailprotected] |
| Length (mm) | 76 |
| Width (mm) | 49.2 |
| Height (mm) | 21.6 |
| Weight (gm) | 34 |
| Shipment Weight | 0.037 kg |
| Shipment Dimensions | 8 6 2 cm |
Sold out!
- This is an infrared sensor kit, which is used to automate the door opening and closing at any place. The sensor comes in two parts a transmitter and a receiver. The sensor works on the principle of infrared radiation that means if the infrared beam from the transmitter is broken then the receiver will activate the output.
Features:
- High-Quality Enclosure to Protect the Sensor
- Works On Infrared Technology
- Can Work in Weather Conditions Like Fog, Rain, Dust, etc.
- Easy to Install
You must be logged in to post a review.
Related products
BC327 PNP General Purpose Amplifier Transistor
₹1.92 + GSTAdd to cartBC327 is a general purpose PNP BJP transistor that can be used for switching and amplification purposes in electronic circuits. The transistor features 800mA collector current hence it can be used to drive variety of loads in an electronic application. The max collector-emitter voltage is -45V therefore it can easily handle load voltage under 45V. Apart from that transistor also features 625mW collector dissipation and DC current gain of maximum 630 therefore it can also be used as an audio amplifier or for any type of signal amplification.
Quartz Crystal Oscillator 16MHz HC-49S 2 Pin for TV, car Electronics, PC Card, Electronic Watch, DVD, MP3v
₹6.72 + GSTAdd to cartCrystal Oscillators are used as a quick and easy way to offer circuits a very accurate and consistent frequency output. This 16 MHz Crystal is a thru-hole type and is typically used with microcontrollers.- Add to cart
- Decade counter/decimal decode display (CD4017B)
- Binary counter/decoder
- Frequency division
- Counter control/timers
- Divde-by-N counting
- For further application information, see ICAN-6166 “COS/MOS MSI Counter and Register Design and Applications”
- Add to cart
Specification
- This relay module is 5 Volts active low.
- It is an 8-channel relay interface board, which can be controlled directly by a wide range of microcontrollers such as Arduino, AVR, PIC, ARM, PLC, etc.
- It is also able to control various appliances and other equipments with large current.
- Relay output maximum contact is AC250V 10A and DC30V 10A.
- Standard interface can be directly connected with microcontrollers.
- Red working status indicator lights are conducive to the safe use.
- Widely used for all MCU control, industrial sector, PLC control, smart home control.
- Input port IN1, IN2, IN3, IN4, IN5, IN6, IN7, IN8 low signal level effectively.
- VCC, GND : Input power.
- JD – VCC : Relay power input port,relay can power alone.
- Working voltage : 5V
- Module weight : about 112g
- package weight : about 150g
- module size : about 1.7cm X 5.5cm X 13.7cm(height * width * long)
- Add to cart
2N2222 is NPN BJT?normally used in low power amplifiers and also for switching application.
2n2222 is used as a?small signal transistor?and used as a general purpose transistor and is very popular. ?This is in TO-92 package form.
Reviews
There are no reviews yet.