CLEANING PUMP HP 7612 PRINTER MT2446V05-2
Proximity Sensor M8 PNP NO 36VDC
CPU Cooling Fan 8025 12V Axial Blowers
GPJ15J 4264
KT-General Purpose Relay459
Reed Switch Sensor Module
Features:-
- Open reed switch
- Working voltage: 3.3V ~ 5V
- Current: Upto 1.2A
- Comparator output, clean signal, great waveform, and strong driving ability
- Digital switch output (0 and 1)
- Fixed bolt hole for easy installation
ADS1115 16-Bit I2C ADC 4-Channel Programmable Gain Amplifier Module
Features
- WIDE SUPPLY RANGE: 2.0V to 5.5V
- PROGRAMMABLE DATA RATE: 8SPS to 860SPS
- It has an Internal low-drift voltage reference
- Internal Oscillator.
- Internal PGA.
- I2C INTERFACE : Pin-Selectable Addresses.
- Four single ends Or Two differential inputs.
2 Channel 5V SSR Solid State Relay Module
Features
- 2 channel 2 AMP Solid State Relay board
- Control 2 loads of up to 2 amps each at 120V or 240V AC.
- Good for lighting, holiday displays etc.
- Has been assembled, and the electrical test passed.
- Led indicator for each relay.
Miss Minute Clock From Loki (3d Printed)
150 RPM Single Shaft L- Shaped BO Motor
Features :-
- Cost-effectiveness of the injection-molding process.
- Elimination of machining operations.
- Low density: lightweight, low inertia.
- Uniformity of parts.
- Capability to absorb shock and vibration as a result of elastic compliance.
- Ability to operate with minimum or no lubrication, due to inherent lubricity.
- The relatively low coefficient of friction.
- Corrosion-resistance; elimination of plating, or protective coatings.
- The quietness of operation.
- Tolerances are often less critical than for metal gears, due in part to their greater resilience.
- Consistency with the trend to greater use of plastic housings and other components.
Force Sensor – 39.1mm
- This is a Force sensitive resistor with a square, 1.75x1.5",sensing area. This FSR will vary its resistance depending on how much pressure is being applied to the sensing area. The harder the force, the lowerthe resistance. When no pressure is being applied to the FSR its resistance will be larger than 1M. This FSR can sense applied force anywhere in the range of 100g-10kg.
- Two pins extend from the bottom of the sensor with 0.1" pitch making it bread board friendly. There is a peel-and-stick rubber backing on the other side of the sensing area to mount the FSR.
- Just Connect a resistor to form a voltage divider and measure the voltage at the junction to find the force applied. These sensors are simple to set up and great for sensing pressure, but they aren't incredibly accurate. Use them to sense if it's being squeezed, but you may not want to use it as a scale.
