Free delivery on orders above Rs 900 | Single Delivery charges for Multiple Items

Cart

Your Cart is Empty

Back To Shop

Cart

Your Cart is Empty

Back To Shop

Search Results for: microcontroller

Showing 1–16 of 17 results

  • 8051 / AT89S52 /AT89S52-24pu at89s52 dip-40 atmel microcontroller chip ic

    Original price was: ₹110.00.Current price is: ₹63.96. + GST

    Features:

    1. 8K Bytes of In-System Reprogrammable Flash Memory
    2. Endurance: 1,000 Write/Erase Cycles
    3. Fully Static Operation: 0 Hz to 33 MHz
    4. Three-level Program Memory Lock
    5. 256 x 8-Bit Internal RAM
    6. 32 Programmable I/O Lines
    7. Three 16-bit Timer/Counters
    8. Eight Interrupt Sources
    9. Programmable Serial Channel
    10. Low Power Idle and Power Down Modes
    Add to cart
  • TSOP 1738 38Mhz IR Infrared Receiver PCM Remote Control Sensor Module for Arduino,8051,AVR,PIC,ARM,MSP,Raspberr Pi Microcontroller

    Original price was: ₹30.00.Current price is: ₹20.50. + GST

    The TSOP1738 is a miniaturized receiver for infrared remote control systems. A PIN diode and a preamplifier are assembled on a lead frame while the epoxy package acts as an IR filter. The demodulated output signal can be directly decoded by a microprocessor. The TSOP1738 is compatible with all common IR remote control data formats.

    Add to cart
  • ATmega328P-U Microcontroller without BootLoader

    Original price was: ₹695.52.Current price is: ₹210.00. + GST
    This is ATmega328P-PU IC which also known as ATmega328P-U. So you may receive IC with printed name ATmega328P-U.
    The ATMEGA328P- U is a low-power CMOS 8-bit microcontroller based on the AVR enhanced RISC architecture. By executing powerful instructions in a single clock cycle, the ATmega328P-PU achieves throughputs approaching 1 MIPS per MHz allowing the system designer to optimize power consumption versus processing speed.
    Add to cart
  • Lcd 16X2 Yellow Backlight Alphanumeric Display for 8051,Avr,Arduino,Raspberry Pi,Pic,Arm All Microcontroller (Green)

    Original price was: ₹112.00.Current price is: ₹91.82. + GST
    • Operating Voltage is 4.7V to 5.3V
    • Current consumption is 1mA without backlight
    • Alphanumeric LCD display module, meaning can display alphabets and numbers
    • Consists of two rows and each row can print 16 characters.
    • Each character is build by a 5?8 pixel box
    • Can work on both 8-bit and 4-bit mode
    • It can also display any custom generated characters
    • Available in Green Backlight
    Add to cart
  • AC/DC Yellow Panel Indicator 24V

    Original price was: ₹50.00.Current price is: ₹37.72. + GST

    Specification

    • High-strength Polycarbonate lampshade material
    • Indicator Lamp is anti-interference signal Lamp
    • Built-in screw wire is more safe and convenient
    • Colour : Yellow
    • Input Voltage : 24 Volts AC/DC
    • Mounting depth : Approx. 29mm /1.1″.
    • Size : Fit for 22mm-25mm/0.86″-0.98″ diameter mounting hole, Panel Mounted
    Add to cart
  • BT136 600D triac logic sensitive gate 600v 4a to220ab

    Original price was: ₹10.00.Current price is: ₹7.00. + GST
    • BT136?is Planar passivated very sensitive gate four quadrant?TRIAC?in a?SOT78?plastic package intended for use in general purpose bidirectional switching and phase control applications, where high sensitivity is required in all four quadrants. This very sensitive gate “series D” triac is intended to be interfaced directly to microcontrollers, logic integrated circuits and other low power gate trigger circuits.
    Add to cart
  • DC 3-5V Temperature Sensor Thermocouple Sensor for Arduino

    Original price was: ₹70.00.Current price is: ₹54.12. + GST

    Features of KY 028 NTC Temprature Sensor Module

    • NTC Thermistor sensor
    • LM393 voltage comparator
    • Mounting hole for easy installation
    • Adjustable threshold via potentiometer

    Specifications of?NTC Temprature Sensor Module

    • Operating Voltage : 3.3 to 5 Volts
    • Output Current : 15 mA
    • Output Type : Digital (HIGH OR LOW)
    Add to cart
  • 1.3 inch Blue OLED Display Module with I2C/IIC Serial Interface for boards compatible with Arduino

    Original price was: ₹500.00.Current price is: ₹278.41. + GST
    • This is small 1.3″ I2C interface OLED 128×64 dot matrix Display module.?This OLED Display Module is very compact and will add a great ever user interface experience to your Arduino or any Microcontroller project. The connection of this display with Arduino is made through I2C interface.
    • The SH1106 1.3 Inch 128?64 OLED Display Screen Module produces blue text on black background with very good contrast when supplied with DC 3.3 Volts to 5 Volts supply. The OLED Display Modules also offers a very wide viewing angle of about greater than 160?
    Read more
  • NRF24L01 2.4GHz Wireless Transceiver Module

    Original price was: ₹100.00.Current price is: ₹50.02. + GST
    • Has on board antenna. The nRF24L01 is a single chip 2.4GHz transceiver with an embedded baseband protocol engine (Enhanced ShockBurst?), designed for ultra low power wireless applications.
    • The nRF24L01 is designed for operation in the world wide ISM frequency band at 2.400 – 2.4835GHz. An MCU (microcontroller) and very few external passive components are needed to design a radio system with the nRF24L01. The nRF24L01 is configured and operated through a Serial Peripheral Interface (SPI.) Through this interface the register map is available. The register map contains all configuration registers in the nRF24L01 and is accessible in all operation modes of the chip.
    • The embedded baseband protocol engine (Enhanced ShockBurst?) is based on packet communication and supports various modes from manual operation to advanced autonomous protocol operation. Internal FIFOs ensure a smooth data flow between the radio front end and the system?s MCU. Enhanced ShockBurst? reduces system cost by handling all the high-speed link layer operations. The radio front end uses GFSK modulation. It has user configurable parameters like frequency channel, output power and air data rate.
    • DNA Solutions has large collection of various types of Transceiver Module. Check our complete collection of Transceiver Module
    Add to cart
  • ISD1820 Voice Record Module

    Original price was: ₹200.00.Current price is: ₹131.00. + GST
    • It can offers true single?chip voice recording, no?volatile storage, and playback capability for 8 to 20 seconds. The sample is 3.2k and the total 20s for the Recorder. This module use is very easy which you could direct control by push button on board or by Microcontroller such as Arduino, STM32, ChipKit etc. From these, you can easy control record , playback and repeat and so on.
    • We have Various sizes of Audio, Sound and Voice Module. Check out our complete collection of Audio, Sound and Voice Module.
    Add to cart
  • MAX7219 8×8 LED Dot Matrix Display Module

    Original price was: ₹160.00.Current price is: ₹128.30. + GST

    he individual module features 8?8 LED?s, each controlled very precisely by?the MAX7219 driver to generate the color pattern you wish. The great advantage of using this is users will have control over all of the 64 LED by just connecting 3 output communication wires to microcontrollers like Arduino etc.

    Add to cart
  • Zener Voltage Regulator Diode 4.7 Volt 0.5 Watt

    Original price was: ₹2.42.Current price is: ₹2.02. + GST
    • Used in Voltage protection circuits
    • Can be used as low current voltage regulator
    • Input voltage protection for Microcontrollers or other IC?s
    • Voltage stabilizing circuits
    Add to cart
  • Magnetic Door Sensor

    Original price was: ₹70.00.Current price is: ₹52.00. + GST

    MC-38 Wired Door Window Sensor Magnetic Switch Home Alarm System can be used as a door or window security system. It produces the signal when moved away from each other which can be fed to the microcontroller to perform the desired action as per requirement.

    Add to cart
  • UNO R3 SMD Board compatible with Arduino | Development Board

    Original price was: ₹600.00.Current price is: ₹598.00. + GST

    Arduino UNO R3 SMD is the open source Embedded Development board launched by Arduino based on Atmega328 SMD Package Microcontroller.?Because Atmel is moving more and more of their production capacity to surface mount ICs, the DIP packaged ATmega is becoming more and more difficult to get.

    Add to cart
  • MEGA 2560 R3 (ATmega2560-16AU CH340G) compactable with Arduino AVR

    Original price was: ₹2,700.00.Current price is: ₹2,075.50. + GST

    The Arduino Mega 2560 R3 is an open source precise microcontroller board Successor to the Arduino Mega based on the ATmega2560 SMD chip.The Mega 2560 R3 also adds SDA and SCL pins next to the AREF. In addition, there are two new pins placed near the RESET pin. One is the IOREF that allow the shields to adapt to the voltage provided from the board. The other is a not connected and is reserved for future purposes. The Mega 2560 R3 works with all existing shields but can adapt to new shields which use these additional pins.

    Add to cart
  • LDR Light Sensor Module Photosensitive Based on LM393 for Arduino and Other MCU

    Original price was: ₹40.00.Current price is: ₹28.29. + GST

    This?LM393 Photosensitive Light Dependent Sensor Module?is using a high-quality LM393?voltage comparator. Easy to install using the sensitive type photosensitive resistance sensor the?comparator output signal gives a clean and good waveform.

    Add to cart

Cart

Your Cart is Empty

Back To Shop
GET DISCOUNT CODE

It will take just few seconds to claim 7% Discount, After Submitting check Email for Coupon code.

    X
    GET DISCOUNT CODE