DS1307 Real Time Clock (RTC) I2C IIC Module AT24C32 without Battery
₹73.63
This is Tiny RTC Real Time Clock DS1307 I2C IIC Module for Arduino. It contains a DS1307 real-time clock IC with a backup battery. It’s one of the easiest to use RTCs out there, with Arduino and other libraries or simply use I2C commands to set and retrieve the time and date. Includes a lithium coin cell battery which should be good for four years at least.
18 in stock
- Operating Voltage: 5V
- Two wire I2C interface
- Hour: Minutes: Seconds AM/PM
- Leap year compensation
- Accurate calendar up to the year 2100
- Consumes Less than 500nA in Battery-Backup
11 reviews for DS1307 Real Time Clock (RTC) I2C IIC Module AT24C32 without Battery
Related products
- Add to cart
1-Channel Solid-State Relay is some what similar to that of a mechanical relay & the difference is that, there is no moving contact in a Solid-State Relay. Here we make use of Phototropic coupler to turn it ON and OFF.
- Add to cart
Relays are output devices which are used to control or operate some external devices. This is a 5 volt Isolated relay module which means that there is a optocoupler used in between your control circuit and the relay thus protecting your circuit in case of any short circuit issues on the relay side.
- Add to cart
- Supply Voltage : 7V
- Input Voltage : 5.5V
- Operating Free Air Temperature Range : 0°C to +70°C
- Storage Temperature Range : −65°C to +150°C
- Add to cart
Specification
- This relay module is 5 Volts active low.
- It is an 8-channel relay interface board, which can be controlled directly by a wide range of microcontrollers such as Arduino, AVR, PIC, ARM, PLC, etc.
- It is also able to control various appliances and other equipments with large current.
- Relay output maximum contact is AC250V 10A and DC30V 10A.
- Standard interface can be directly connected with microcontrollers.
- Red working status indicator lights are conducive to the safe use.
- Widely used for all MCU control, industrial sector, PLC control, smart home control.
- Input port IN1, IN2, IN3, IN4, IN5, IN6, IN7, IN8 low signal level effectively.
- VCC, GND : Input power.
- JD – VCC : Relay power input port,relay can power alone.
- Working voltage : 5V
- Module weight : about 112g
- package weight : about 150g
- module size : about 1.7cm X 5.5cm X 13.7cm(height * width * long)
- Add to cartCrystal Oscillators are used as a quick and easy way to offer circuits a very accurate and consistent frequency output. This 16 MHz Crystal is a thru-hole type and is typically used with microcontrollers.
Rahul (verified owner) –
Best cost electronic components in India
Harsh (verified owner) –
Less cost than other websites
Roma (verified owner) –
Good quality.
Sneha (verified owner) –
Drone parts i ordered and found ok
Devendra (verified owner) –
Good techinical knowledge
Ketan (verified owner) –
Best cost electronic components in India
Priya (verified owner) –
Less cost than other websites
Zohar (verified owner) –
Less cost than other websites
Priya (verified owner) –
Good support and recommended
Devendra (verified owner) –
Good quality.
Shubham (verified owner) –
Less cost than other websites