Mosfet IRF540NPBF IRF540N – 100V , 33A – Dip Component, For Power, TH
Original price was: ₹30.00.₹21.38Current price is: ₹21.38. + GST
53 in stock
Specification
| Brand |
IR
|
| Part Number |
IRF540NPBF
|
| Product Type |
Mosfet
|
| Usage/Application |
Power
|
| Mounting Type |
Through Hole
|
| Pin Count |
3 PIN
|
| Part No |
IRF540N
|
You must be logged in to post a review.
Related products
-
Optocoupler High Level Relay Module Board 5V 4-CH for PIC ARM DSP AVR | Compatible with Arduno NodeMCU Raspberry Pi | Pack of 1 | Blue (Excellent Quality)
Original price was: ₹139.00.₹136.50Current price is: ₹136.50. + GSTAdd to cartSpecification
- Size : 75mm (length) x 55mm (W) x 19.3mm (height);
- Weight : 80g;
- PCB Color : Blue;
- board four weeks with four screw holes, hole diameter 3.1mm, easy to install and fixed;
- Relay selection of quality loose music relays, SPDT. A common terminal, a normally open, one normally closed terminal;
- optocoupler isolation, good anti-jamming;
- Low pull, high release. Energisation status indicator light, release status LED is off;
- VCC for the system power, JD_VCC for the relay power. Default hair 12V relay, plug the jumper cap to;
- Relay Maximum output : DC 30V/10A, AC 250V/10A
- Wiring : VCC : positive power supply system GND : System power supply negative IN1 ? IN4 : relay control ports
-
Voltage Sensor Module 25VDC
Original price was: ₹16.00.₹15.08Current price is: ₹15.08. + GSTAdd to cartThis DC Voltage Sensor Module is essentially a 5:1 potential divider circuit built using precession resistors for high accuracy.
The Arduino analog input is limited to a 5 VDC input.? If you wish to measure higher voltages,this module allows you to measure voltages of 0-25V. Keep in mind, you are restricted to voltages that are less than 25 volts. More than that and you will exceed the voltage limit of your Arduino input.
-
Crystal Oscillator 8 MHZ
Original price was: ₹15.00.₹6.72Current price is: ₹6.72. + GSTAdd to cartThis is a 8MHZ Crystal. This is a low cost crystal oscillator with?oscillation frequency of 8Mhz. Crystal are normally required to provide?clock pulses to your micro controller or other IC’s which require external clock?source.
An oscillator crystal has two electrically conductive plates, with a slice or?tuning fork of quartz crystal sandwiched between them. The crystal oscillator?circuit sustains oscillation by taking a voltage signal from the quartz?resonator, amplifying it, and feeding it back to the resonator. Quartz has the?further advantage that its elastic constants and its size change in such a way?that the frequency dependence on temperature can be very low.
-
Quartz Crystal Oscillator 16MHz HC-49S 2 Pin for TV, car Electronics, PC Card, Electronic Watch, DVD, MP3v
Original price was: ₹15.00.₹6.72Current price is: ₹6.72. + GSTAdd to cartCrystal Oscillators are used as a quick and easy way to offer circuits a very accurate and consistent frequency output. This 16 MHz Crystal is a thru-hole type and is typically used with microcontrollers. -
100 MM x 2.5 MM, Nylon Zip Wire Organizer/Self Locking
Original price was: ₹10.00.₹1.64Current price is: ₹1.64. + GSTAdd to cartThis is a?100 x 2.5 mm Nylon cable tie?also known as hose tie or Zip tie. The?cable tie?is perfect for holding items together specially electric cables or wires.? The flexible design of the?cable tie?makes it easier to slip the ties under and around wire harness. Thanks to the teeth on one of the side of the belt makes it easier for self locking and securing the wires.
Reviews
There are no reviews yet.