-30%
KT-General Purpose Relay459
Original price was: ₹90.00.₹78.00Current price is: ₹78.00. + GST
TSOP1838 METAL 38KHZ IR DISTANCE SENSOR RECEIVER
Original price was: ₹15.00.₹11.05Current price is: ₹11.05. + GST
IL339N IC
Original price was: ₹20.00.₹14.00Current price is: ₹14.00. + GST
3 in stock
Related products
BC547 NPN General Purpose Transistor
BC547 is a general purpose BJT NPN transistor mostly used in electronics hobbyists and educational electronics projects. Besides these uses it can also be used in commercial circuits. It comes in TO-92 packaging and the maximum output current this transistor can handle is 100mA. The transistor is having very good DC current gain and low noise capabilities due to which it is ideal to use in signal amplification stages. The typical saturation voltage is only 90 millivolts which is also a good sign to use it as a switch.
5.5mm x 2.1mm 3 Pin Female DC Power Jack Panel Mount Screw Nut Kit DC Socket Electrical Plug
- Widely used in small-scale as well as prototyping projects where 12 to 30 volts power supply needed
- Supports DC Power Jack: 2.1 x 5.5 mm
- Diameter: 14mm
HC-05 Bluetooth Module
Bluetooth module (SMD) using chipsets BlueCore4 CSR. It has seven I / O ports, 8 Mbit flash memory for software storage and two modes of operation: via AT commands and transparently. In transparent mode it can be configured as Master, Slave or Loopback, and can connect to other devices that support SPP. In the AT command mode, the user can configure the module and send commands. By controlling the logic level of pin PIO11, the user can activate the work mode between AT command and transparent. Perfect for use in various electronics projects in India, HC-05 Bluetooth Module ensures reliability and performance. Ideal for various electronics projects, HC-05 Bluetooth Module offers quality and performance.
L298N Motor Driver Controller Board
It can control upto 4 DC motors, or 2 DC motors with directional and speed control. It can drive motors upto 46V with a total DC current of up to 4A. You can connect the two channels in parallel to double the maximum current or in series to double the maximum input voltage. Perfect for use in various electronics projects in India, L298N Motor Driver Controller Board Module | Dual H-Bridge DC Stepper Driver for Arduino | NodeMCU | Raspberry Pi Development Board - ensures reliability and performance. Ideal for various electronics projects, L298N Motor Driver Controller Board Module | Dual H-Bridge DC Stepper Driver for Arduino | NodeMCU | Raspberry Pi Development Board - offers quality and performance.
74HC595 8-bit Shift Register IC
The 74HC595 consists of an 8?bit shift register and an 8?bit D?typelatch with three?state parallel outputs. The shift register accepts serialdata and provides a serial output. The shift register also providesparallel data to the 8?bit latch. The shift register and latch haveindependent clock inputs. This device also has an asynchronous resetfor the shift register.The HC595 directly interfaces with the SPI serial data port onCMOS MPUs and MCUs
Original Flex sensor 2.2 inches for Motion and Diy
Flex sensors are usually available in two sizes. One is 2.2 inch and another is 4.5 inch. Although the sizes are different the basic function remains the same. They are also divided based on resistance. There are LOW resistance, MEDIUM resistance and HIGH resistance types. Choose the appropriate type depending on requirement. Here we are going to discuss 2.2inch Flex sensor that is FS-L-0055. Perfect for use in various electronics projects in India, Original Flex sensor 2.2 inches for Motion and Diy ensures reliability and performance. Ideal for various electronics projects, Original Flex sensor 2.2 inches for Motion and Diy offers quality and performance.
DHT11 Temperature and Humidity sensor
The DHT11 is a commonly used Temperature and humidity sensor. The sensor comes with a dedicated NTC to measure temperature and an 8-bit microcontroller to output the values of temperature and humidity as serial data. The sensor is also factory calibrated and hence easy to interface with other microcontrollers.