30A Range Electrical Parts Current Sensor Module ACS712 for Arduino
₹89.81 + GST
The 30A range Current Sensor Module ACS712 consists of a precise, low-offset, linear Hall circuit with a copper conduction path located near the surface of the die. Applied current flowing through this copper conduction path generates a magnetic field in which the Hall IC converts into a proportional voltage.
2 in stock
- Low-noise analog signal path
- Device bandwidth is set via the new FILTER pin
- 5 ?s output rise time in response to step input current
- Small footprint, low-profile SOIC8 package
- 2.1 kVRMS minimum isolation voltage from pins 1-4 to pins 5-8
- Supply Voltage: 4.5V~5.5V DC
- Measure Current Range: 30A
- Sensitivity: 100mV/A
13 reviews for 30A Range Electrical Parts Current Sensor Module ACS712 for Arduino
You must be logged in to post a review.
Related products
7476 Dual Master-Slave J-K Flip-Flop
₹61.50 + GSTAdd to cart- Supply Voltage : 7V
- Input Voltage : 5.5V
- Operating Free Air Temperature Range : 0?C to +70?C
- Storage Temperature Range : ?65?C to +150?C
BC547 NPN General Purpose Transistor
₹0.98 + GSTAdd to cartBC547 is a general purpose BJT NPN transistor mostly used in electronics hobbyists and educational electronics projects. Besides these uses it can also be used in commercial circuits. It comes in TO-92 packaging and the maximum output current this transistor can handle is 100mA. The transistor is having very good DC current gain and low noise capabilities due to which it is ideal to use in signal amplification stages. The typical saturation voltage is only 90 millivolts which is also a good sign to use it as a switch.
- Add to cart
2N2222 is NPN BJT?normally used in low power amplifiers and also for switching application.
2n2222 is used as a?small signal transistor?and used as a general purpose transistor and is very popular. ?This is in TO-92 package form.
- Add to cart
BC557 is a widely used PNP bipolar junction transistor manufactured in small TO-92 package. It is a general purpose PNP transistor that can be used as a switch or amplifier in electronic circuits. Its HFE ratings are 125 to 800 which makes it an ideal transistor to use as a small signal amplifier in electronic circuits for example for audio signal amplification or other, the HFE ratings of BC557 can be determined by the last letter after its number for example BC557A HFE ratings are 110-220, BC557B HFE ratings are 200-450 and BC557C HFE ratings are 420-800. The max collector dissipation is 500 milliwatt which is also an another good point to use it in amplification stages. Moreover it will also perform well when used it as a switch for load under 100mA. The transistor has also good collector to emitter (VCE) value that is -45V, therefore you can easily use it in circuits using 40 to 45 volts DC.
- Add to cartCore processor ESP8266 in smaller sizes of the module encapsulates Tensilica L106 integrates industry-leading ultra low power 32-bit MCU micro, with the 16-bit short mode, Clock speed support 80 MHz, 160 MHz, supports the RTOS, integrated Wi Fi MAC/BB/RF/PA/LNA, on-board antenna.
Lokesh (verified owner) –
Online best cost electronic components
Sneha (verified owner) –
Good support and recommended
Shubham (verified owner) –
Drone parts i ordered and found ok
Sneha (verified owner) –
Good techinical knowledge
Rahul (verified owner) –
The product is firmly packed.
Er.Prashant (verified owner) –
Very fast delivery.
Akshay (verified owner) –
Good techinical knowledge
Paaji (verified owner) –
I got my project done with these components Great Support
Harsh (verified owner) –
Good quality.
Paaji (verified owner) –
Drone parts i ordered and found ok
Lokesh (verified owner) –
Good support and recommended
Paaji (verified owner) –
Very well worth the money.
Rohit (verified owner) –
Good quality.