Search Results for: NodeMCU
Showing all 5 results
-
Compactable with NodeMCU LUA WIFI Internet Development Board Based on ESP8266 CP2102
Original price was: ₹500.00.₹253.50Current price is: ₹253.50. + GSTRead moreSpecification
- 11 b/g/n Wi-Fi Direct (P2P), soft-AP
- Integrated TCP/IP protocol stack
- CP2102 Serial / USB Chip
- +19.5dBm output power in 802.11b mode
- 4MB Flash Memory
- Integrated low power 32-bit CPU
- SDIO 1.1 / 2.0, SPI, UART
- Dimensions ? 49 x 24.5 x 13mm
- Integrated TR switch, balun, LNA, power amplifier and matching network
- Integrated PLLs, regulators, DCXO and power management units
- On board USB to serial chip to easily program and upload codes from the Arduino IDE
- Embeds logic level converter circuits
- Has on board 3.3V regulator to ensure enough power to function as your go-to WiFi chip!
- Easy access to the GPIO pins for easy prototyping
- ESP-12E Processor
- Easy to use breadboard friendly form factor
- Voltage Regulator / Converter, excellent DC to DC conversion, super efficient
-
L298N Motor Driver Controller Board Module | Dual H-Bridge DC Stepper Driver for Arduino | NodeMCU | Raspberry Pi Development Board –
Original price was: ₹160.00.₹110.00Current price is: ₹110.00. + GSTAdd to cartIt can control upto 4 DC motors, or 2 DC motors with directional and speed control. It can drive motors upto 46V with a total DC current of up to 4A. You can connect the two channels in parallel to double the maximum current or in series to double the maximum input voltage.
-
Lolin NodeMCU ESP8266 CH340 NodeMCU WIFI Serial Wireless Module
Original price was: ₹300.00.₹187.87Current price is: ₹187.87. + GSTAdd to cartNodeMCU is aIoT Module based on?ESP8266 wifi Module. NodeMCU uses Lua Scripting language and is an open source Internet of Things (IoT)?platform. This modules has CH340g USB to TTL IC.
-
Optocoupler High Level Relay Module Board 5V 4-CH for PIC ARM DSP AVR | Compatible with Arduno NodeMCU Raspberry Pi | Pack of 1 | Blue (Excellent Quality)
Original price was: ₹139.00.₹136.50Current price is: ₹136.50. + GSTAdd to cartSpecification
- Size : 75mm (length) x 55mm (W) x 19.3mm (height);
- Weight : 80g;
- PCB Color : Blue;
- board four weeks with four screw holes, hole diameter 3.1mm, easy to install and fixed;
- Relay selection of quality loose music relays, SPDT. A common terminal, a normally open, one normally closed terminal;
- optocoupler isolation, good anti-jamming;
- Low pull, high release. Energisation status indicator light, release status LED is off;
- VCC for the system power, JD_VCC for the relay power. Default hair 12V relay, plug the jumper cap to;
- Relay Maximum output : DC 30V/10A, AC 250V/10A
- Wiring : VCC : positive power supply system GND : System power supply negative IN1 ? IN4 : relay control ports
-
ESP-12E: ESP8266 Serial Port WIFI Wireless Transceiver Module For Arduino
Original price was: ₹107.00.₹104.52Current price is: ₹104.52. + GSTAdd to cartFeatures :
- WS2812 Led on board.
- 802.11 b/g/n
- Wi-Fi Direct (P2P), soft-AP
- Integrated TCP/IP protocol stack
- Integrated TR switch, balun, LNA, power amplifier and matching network
- Integrated PLL, regulators, DCXO and power management units
- +19.5dBm output power in 802.11b mode
- Power down leakage current of <10uA
- Integrated low power 32-bit CPU could be used as an application processor
- SDIO 1.1 / 2.0, SPI, UART
- STBC, 1?1 MIMO, 2?1 MIMO
- A-MPDU & A-MSDU aggregation & 0.4ms guard interval
- Wake up and transmit packets in < 2ms
- Standby power consumption of < 1.0mW (DTIM3)
- Access Point and Station Modes.