![2k 100W Ohm Variable Resistor 1 2k 100W Ohm Variable Resistor WhatsApp Image 2022 07 23 at 1.30.40 PM 1 2k 100W Ohm Variable Resistor](https://i0.wp.com/smartxprokits.in/wp-content/uploads/2022/07/WhatsApp-Image-2022-07-23-at-1.30.40-PM-1.jpeg?fit=600%2C600&ssl=1)
![2k 100W Ohm Variable Resistor 2 2k 100W Ohm Variable Resistor WhatsApp Image 2022 07 23 at 1.30.40 PM 1 2k 100W Ohm Variable Resistor](https://i0.wp.com/smartxprokits.in/wp-content/uploads/2022/07/WhatsApp-Image-2022-07-23-at-1.30.40-PM-1.jpeg?resize=100%2C100&ssl=1)
2k 100W Ohm Variable Resistor
₹300.00 Original price was: ₹300.00.₹204.18Current price is: ₹204.18. + GST
11 in stock
Type : Adjustable
Rated Power : 100W
Resistance : 2K ?;
Diameter in CM:? 3 cm
Length In CM : 15 cm
Inner Diameter : 2cm
Color : Green
Material : Metal, Ceramic
You must be logged in to post a review.
Related products
-
Rated 4.55 out of 5
Quality ESP-12F ESP8266 Remote Serial Port WIFI Transceiver Wireless Module
₹130.00Original price was: ₹130.00.₹97.00Current price is: ₹97.00. + GSTAdd to cartCore processor ESP8266 in smaller sizes of the module encapsulates Tensilica L106 integrates industry-leading ultra low power 32-bit MCU micro, with the 16-bit short mode, Clock speed support 80 MHz, 160 MHz, supports the RTOS, integrated Wi Fi MAC/BB/RF/PA/LNA, on-board antenna. -
Rated 5.00 out of 5
BC557 PNP General Purpose Transistor 45V 100mA TO-92 Package
₹5.00Original price was: ₹5.00.₹1.17Current price is: ₹1.17. + GSTAdd to cartBC557 is a widely used PNP bipolar junction transistor manufactured in small TO-92 package. It is a general purpose PNP transistor that can be used as a switch or amplifier in electronic circuits. Its HFE ratings are 125 to 800 which makes it an ideal transistor to use as a small signal amplifier in electronic circuits for example for audio signal amplification or other, the HFE ratings of BC557 can be determined by the last letter after its number for example BC557A HFE ratings are 110-220, BC557B HFE ratings are 200-450 and BC557C HFE ratings are 420-800. The max collector dissipation is 500 milliwatt which is also an another good point to use it in amplification stages. Moreover it will also perform well when used it as a switch for load under 100mA. The transistor has also good collector to emitter (VCE) value that is -45V, therefore you can easily use it in circuits using 40 to 45 volts DC.
-
Rated 4.56 out of 5
Quartz Crystal Oscillator 16MHz HC-49S 2 Pin for TV, car Electronics, PC Card, Electronic Watch, DVD, MP3v
₹15.00Original price was: ₹15.00.₹6.72Current price is: ₹6.72. + GSTAdd to cartCrystal Oscillators are used as a quick and easy way to offer circuits a very accurate and consistent frequency output. This 16 MHz Crystal is a thru-hole type and is typically used with microcontrollers. -
Rated 4.00 out of 5
BC327 PNP General Purpose Amplifier Transistor
₹5.00Original price was: ₹5.00.₹1.95Current price is: ₹1.95. + GSTAdd to cartBC327 is a general purpose PNP BJP transistor that can be used for switching and amplification purposes in electronic circuits. The transistor features 800mA collector current hence it can be used to drive variety of loads in an electronic application. The max collector-emitter voltage is -45V therefore it can easily handle load voltage under 45V. Apart from that transistor also features 625mW collector dissipation and DC current gain of maximum 630 therefore it can also be used as an audio amplifier or for any type of signal amplification.
-
Optocoupler High Level Relay Module Board 5V 4-CH for PIC ARM DSP AVR | Compatible with Arduno NodeMCU Raspberry Pi | Pack of 1 | Blue (Excellent Quality)
₹139.00Original price was: ₹139.00.₹136.50Current price is: ₹136.50. + GSTAdd to cartSpecification
- Size : 75mm (length) x 55mm (W) x 19.3mm (height);
- Weight : 80g;
- PCB Color : Blue;
- board four weeks with four screw holes, hole diameter 3.1mm, easy to install and fixed;
- Relay selection of quality loose music relays, SPDT. A common terminal, a normally open, one normally closed terminal;
- optocoupler isolation, good anti-jamming;
- Low pull, high release. Energisation status indicator light, release status LED is off;
- VCC for the system power, JD_VCC for the relay power. Default hair 12V relay, plug the jumper cap to;
- Relay Maximum output : DC 30V/10A, AC 250V/10A
- Wiring : VCC : positive power supply system GND : System power supply negative IN1 ? IN4 : relay control ports
Reviews
There are no reviews yet.