2MM NTC Thermistor Temperature Sensor 10k- 5%
₹7.38 + GST
27 in stock
It provides resistance of 10K ohm at 25? C.10K Ohm NTC Thermistor can measure temperatures in the range of -55?C to 125?C. It is a very economical sensor. The thermal cooling time constant for this NTC thermistor (in the air) is less than equal to 20 seconds. The thermistor is widely used in freezers, air conditioners, fire alarms, temperature protection in battery charging systems, engine temperature control, etc. This product is known as 10K Ohm NTC, 10K Ohm NTC Thermistor, 10K Ohm Thermistor, Component, 10K Negative Temperature Coefficient Thermistor, 10K NTC Thermistor, 10K Thermistor.
Specification
- Part No: MF52E103FL395
- Thermistor Type: NTC
- Resistance: 10k ohm
- Thermistor Tolerance: ?5%
- Thermistor Case Style: Radial Leaded
- R/T Curve: 1
- Thermistor temperature range: -55?C to 125?C
- No. of Pins: 2
- Mounting Type: Through Hole
- Head Dia: 2mm
- Lead Spacing: 2 mm
You must be logged in to post a review.
Related products
- Add to cart
1-Channel?Solid-State Relay is some what similar to that of a mechanical relay & the difference is that, there is no moving contact in a Solid-State Relay. Here we make use of Phototropic coupler to turn it ON and OFF.
- Add to cart
- Decade counter/decimal decode display (CD4017B)
- Binary counter/decoder
- Frequency division
- Counter control/timers
- Divde-by-N counting
- For further application information, see ICAN-6166 “COS/MOS MSI Counter and Register Design and Applications”
- Add to cart
Specification
- Size : 75mm (length) x 55mm (W) x 19.3mm (height);
- Weight : 80g;
- PCB Color : Blue;
- board four weeks with four screw holes, hole diameter 3.1mm, easy to install and fixed;
- Relay selection of quality loose music relays, SPDT. A common terminal, a normally open, one normally closed terminal;
- optocoupler isolation, good anti-jamming;
- Low pull, high release. Energisation status indicator light, release status LED is off;
- VCC for the system power, JD_VCC for the relay power. Default hair 12V relay, plug the jumper cap to;
- Relay Maximum output : DC 30V/10A, AC 250V/10A
- Wiring : VCC : positive power supply system GND : System power supply negative IN1 ? IN4 : relay control ports
Voltage Sensor Module 25VDC
₹50.12 + GSTAdd to cartThis DC Voltage Sensor Module is essentially a 5:1 potential divider circuit built using precession resistors for high accuracy.
The Arduino analog input is limited to a 5 VDC input.? If you wish to measure higher voltages,this module allows you to measure voltages of 0-25V. Keep in mind, you are restricted to voltages that are less than 25 volts. More than that and you will exceed the voltage limit of your Arduino input.
- Add to cartCore processor ESP8266 in smaller sizes of the module encapsulates Tensilica L106 integrates industry-leading ultra low power 32-bit MCU micro, with the 16-bit short mode, Clock speed support 80 MHz, 160 MHz, supports the RTOS, integrated Wi Fi MAC/BB/RF/PA/LNA, on-board antenna.
Reviews
There are no reviews yet.