

Long Wire Magnetic Wire Antenna with 3 Meter Cable WiFi Antenna for GSM 2G,3G,4G
₹400.00 ₹345.15
Sold out!
Specification
- Central Frequency: 1575.42 MHz / GPS External Active Antenna- 2 MHz
- Embedded Magnet for easy mounting
- 3 M Cable with SMA Connector
1 review for Long Wire Magnetic Wire Antenna with 3 Meter Cable WiFi Antenna for GSM 2G,3G,4G
Related products
- Rated 5.00 out of 5
1 Channel Relay (Imported) | Optocoupler High Level Relay Module Board 5V 1-CH for PIC ARM DSP AVR | Compatible with Arduno NodeMCU Raspberry Pi | (Excellent Quality))
₹150.00₹107.38Add to cart1-Channel Solid-State Relay is some what similar to that of a mechanical relay & the difference is that, there is no moving contact in a Solid-State Relay. Here we make use of Phototropic coupler to turn it ON and OFF.
- Rated 4.67 out of 5
DHT11 Module Temperature and Humidity sensor Module for boards compatible with Arduino, ARM and other MCU
₹120.00₹104.00Add to cartThe DHT11 is a commonly used Temperature and humidity sensor. The sensor comes with a dedicated NTC to measure temperature and an 8-bit microcontroller to output the values of temperature and humidity as serial data. The sensor is also factory calibrated and hence easy to interface with other microcontrollers.
- Rated 5.00 out of 5
8 Channel 5V Relay Board Expansion Module Optocoupler compatible UNO Raspberry
₹312.00₹300.20Add to cartSpecification
- This relay module is 5 Volts active low.
- It is an 8-channel relay interface board, which can be controlled directly by a wide range of microcontrollers such as Arduino, AVR, PIC, ARM, PLC, etc.
- It is also able to control various appliances and other equipments with large current.
- Relay output maximum contact is AC250V 10A and DC30V 10A.
- Standard interface can be directly connected with microcontrollers.
- Red working status indicator lights are conducive to the safe use.
- Widely used for all MCU control, industrial sector, PLC control, smart home control.
- Input port IN1, IN2, IN3, IN4, IN5, IN6, IN7, IN8 low signal level effectively.
- VCC, GND : Input power.
- JD – VCC : Relay power input port,relay can power alone.
- Working voltage : 5V
- Module weight : about 112g
- package weight : about 150g
- module size : about 1.7cm X 5.5cm X 13.7cm(height * width * long)
- Add to cart
2N2222 is NPN BJTÂ normally used in low power amplifiers and also for switching application.
2n2222 is used as a small signal transistor and used as a general purpose transistor and is very popular.  This is in TO-92 package form.
- Add to cart
It is one of the most popular and long lived switching diodes because of its dependable specifications and low cost. The 1N4148 is useful in switching applications up to about 100 MHz. The 1N4148 comes in a DO-35 glass package for thru-hole mounting.
Vivek (verified owner) –
Good techinical knowledge