2K ohm Multiturn Potentiometer Pot Variable Resistor
₹12.05
Potentiometers are common electronics components that convert rotary or linear motion in to change of resistance. They can be found anywhere where some adjustments are needed, volume control and joysticks.
100 in stock
Potentiometers are common electronics components that convert rotary or linear motion in to change of resistance. They can be found anywhere where some adjustments are needed, volume control and joysticks.
Related products
Voltage Sensor Module
₹61.12Add to cartThis DC Voltage Sensor Module is essentially a 5:1 potential divider circuit built using precession resistors for high accuracy.
The Arduino analog input is limited to a 5 VDC input. If you wish to measure higher voltages,this module allows you to measure voltages of 0-25V. Keep in mind, you are restricted to voltages that are less than 25 volts. More than that and you will exceed the voltage limit of your Arduino input.
- Add to cart
1N4007 is an axial leaded general purpose rectifier in DO-41 package. This device features epoxy flame retardant, low forward voltage drop and high current capability and high reliability.
Add to cart- Widely used in small-scale as well as prototyping projects where 12 to 30 volts power supply needed
- Supports DC Power Jack: 2.1 x 5.5 mm
- Diameter: 14mm
Add to cartThe 74HC595 consists of an 8−bit shift register and an 8−bit D−typelatch with three−state parallel outputs. The shift register accepts serialdata and provides a serial output. The shift register also providesparallel data to the 8−bit latch. The shift register and latch haveindependent clock inputs. This device also has an asynchronous resetfor the shift register.The HC595 directly interfaces with the SPI serial data port onCMOS MPUs and MCUs
Crystal Oscillator 8 MHZ
₹8.20Add to cartThis is a 8MHZ Crystal. This is a low cost crystal oscillator with oscillation frequency of 8Mhz. Crystal are normally required to provide clock pulses to your micro controller or other IC’s which require external clock source.
An oscillator crystal has two electrically conductive plates, with a slice or tuning fork of quartz crystal sandwiched between them. The crystal oscillator circuit sustains oscillation by taking a voltage signal from the quartz resonator, amplifying it, and feeding it back to the resonator. Quartz has the further advantage that its elastic constants and its size change in such a way that the frequency dependence on temperature can be very low.
Reviews
There are no reviews yet.