650 nm 6 mm 5V 5 mW Mini Laser Dot Diode Module Head WL (Red)
₹29.00
This 3 Volt 5mW 650nm Laser Diode is a fun little red laser that emits a laser beam similar to a laser pointer when given 3 Volts of power just like you’d get from two standard AAA or AA batteries.
33 in stock
33 in stock
- Max Light Power : 5mW
- Operating Voltage : 3V DC
- Max Operating Current : 25mA
- Laser Wavelength : 650nm
- Operating Temperature : -36 C to 65 C
- Working Life : More than 1000 hours
- Dimentions :
- Diameter : 6mm
- Length : 13mm
- Wire Length : 47mm
1 review for 650 nm 6 mm 5V 5 mW Mini Laser Dot Diode Module Head WL (Red)
You must be logged in to post a review.
Related products
- Add to cart
BC327 is a general purpose PNP BJP transistor that can be used for switching and amplification purposes in electronic circuits. The transistor features 800mA collector current hence it can be used to drive variety of loads in an electronic application. The max collector-emitter voltage is -45V therefore it can easily handle load voltage under 45V. Apart from that transistor also features 625mW collector dissipation and DC current gain of maximum 630 therefore it can also be used as an audio amplifier or for any type of signal amplification.
- Add to cart
This is a 100 x 2.5 mm Nylon cable tie also known as hose tie or Zip tie. The cable tie is perfect for holding items together specially electric cables or wires. The flexible design of the cable tie makes it easier to slip the ties under and around wire harness. Thanks to the teeth on one of the side of the belt makes it easier for self locking and securing the wires.
- Add to cartCrystal Oscillators are used as a quick and easy way to offer circuits a very accurate and consistent frequency output. This 16 MHz Crystal is a thru-hole type and is typically used with microcontrollers.
- Add to cart
The DHT11 is a commonly used Temperature and humidity sensor. The sensor comes with a dedicated NTC to measure temperature and an 8-bit microcontroller to output the values of temperature and humidity as serial data. The sensor is also factory calibrated and hence easy to interface with other microcontrollers.
- Add to cart
1N4007 is an axial leaded general purpose rectifier in DO-41 package. This device features epoxy flame retardant, low forward voltage drop and high current capability and high reliability.
Ketan (verified owner) –
Good techinical knowledge