USB to TTL Serial Converter Adapter 3.3V Debug Cable TX RX Signal 3 Pin Female Socket FT232RL Chip for Windows 10 8 7 Linux MAC OS (3ft)
₹144.90
- Single chip USB to asynchronous serial data transfer interface.
- Entire USB protocol handled on the chip. No USB specific firmware programming required.
- Fully integrated 1024 bit EEPROM storing device descriptors and CBUS I/O configuration.
- Fully integrated USB termination resistors.
- Fully integrated clock generation with no external crystal required plus optional clock output selection enabling a glue-less interface to external MCU or FPGA.
- Data transfer rates from 300 baud to 3 Mbaud (RS422, RS485, RS232) at TTL levels.
- 128 byte receive buffer and 256 byte transmit buffer utilising buffer smoothing technology to allow for high data throughput.
1 in stock
1 in stock
Specification
- Material : PCB + Electronic Component
- Support 3.3V, 5V
- Main Color : Red
- Chipset : FT232RL
- USB power has over current protection, using 500MA self-restore fuse
- RXD/TXD transceiver communication indicator
- Pin definition : DTR,RXD,TX,VCC,CTS,GND
- Pitch : 2.54mm
- Module Size : About 36mm(length)*17.5mm(width)
- Interface : Mini USB
1 review for USB to TTL Serial Converter Adapter 3.3V Debug Cable TX RX Signal 3 Pin Female Socket FT232RL Chip for Windows 10 8 7 Linux MAC OS (3ft)
You must be logged in to post a review.
Related products
- Add to cart
- Operating Voltage is 4.7V to 5.3V
- Current consumption is 1mA without backlight
- Alphanumeric LCD display module, meaning can display alphabets and numbers
- Consists of two rows and each row can print 16 characters.
- Each character is build by a 5×8 pixel box
- Can work on both 8-bit and 4-bit mode
- It can also display any custom generated characters
- Available in Green Backlight
- Add to cart
1N4007 is an axial leaded general purpose rectifier in DO-41 package. This device features epoxy flame retardant, low forward voltage drop and high current capability and high reliability.
- Add to cart
Relays are output devices which are used to control or operate some external devices. This is a 5 volt Isolated relay module which means that there is a optocoupler used in between your control circuit and the relay thus protecting your circuit in case of any short circuit issues on the relay side.
- Add to cart
1-Channel Solid-State Relay is some what similar to that of a mechanical relay & the difference is that, there is no moving contact in a Solid-State Relay. Here we make use of Phototropic coupler to turn it ON and OFF.
- Add to cart
BC547 is a general purpose BJT NPN transistor mostly used in electronics hobbyists and educational electronics projects. Besides these uses it can also be used in commercial circuits. It comes in TO-92 packaging and the maximum output current this transistor can handle is 100mA. The transistor is having very good DC current gain and low noise capabilities due to which it is ideal to use in signal amplification stages. The typical saturation voltage is only 90 millivolts which is also a good sign to use it as a switch.
Lokesh (verified owner) –
Very well worth the money.