MEGA 2560 R3 (ATmega2560-16AU CH340G) compactable with Arduino AVR
₹2,531.10
The Arduino Mega 2560 R3 is an open source precise microcontroller board Successor to the Arduino Mega based on the ATmega2560 SMD chip.The Mega 2560 R3 also adds SDA and SCL pins next to the AREF. In addition, there are two new pins placed near the RESET pin. One is the IOREF that allow the shields to adapt to the voltage provided from the board. The other is a not connected and is reserved for future purposes. The Mega 2560 R3 works with all existing shields but can adapt to new shields which use these additional pins.
5 in stock
5 in stock
- Microcontroller: ATmega2560
- Operating Voltage: 5V
- Input Voltage (recommended): 7-12V
- Input Voltage (limits): 6-20V
- Digital I/O Pins: 54 (of which 15 provide PWM output)
- Analog Input Pins: 16
- DC Current per I/O Pin: 40 mA
- DC Current for 3.3V Pin: 50 mA
- Flash Memory: 256 KB of which 8 KB used by bootloader
- SRAM: 8 KB
- EEPROM: 4 KB
- Clock Speed: 16 MHz
- USB Host Chip: MAX3421E
- Length:101.98mm/4.01in
- Width:53.63mm/2.11in
- Height:15.29mm/0.60in
13 reviews for MEGA 2560 R3 (ATmega2560-16AU CH340G) compactable with Arduino AVR
Related products
- Add to cart
Relays are output devices which are used to control or operate some external devices. This is a 5 volt Isolated relay module which means that there is a optocoupler used in between your control circuit and the relay thus protecting your circuit in case of any short circuit issues on the relay side.
- Add to cartCrystal Oscillators are used as a quick and easy way to offer circuits a very accurate and consistent frequency output. This 16 MHz Crystal is a thru-hole type and is typically used with microcontrollers.
- Add to cart
BC327 is a general purpose PNP BJP transistor that can be used for switching and amplification purposes in electronic circuits. The transistor features 800mA collector current hence it can be used to drive variety of loads in an electronic application. The max collector-emitter voltage is -45V therefore it can easily handle load voltage under 45V. Apart from that transistor also features 625mW collector dissipation and DC current gain of maximum 630 therefore it can also be used as an audio amplifier or for any type of signal amplification.
Add to cart2N2222 is NPN BJTÂ normally used in low power amplifiers and also for switching application.
2n2222 is used as a small signal transistor and used as a general purpose transistor and is very popular.  This is in TO-92 package form.
- Add to cart
It is one of the most popular and long lived switching diodes because of its dependable specifications and low cost. The 1N4148 is useful in switching applications up to about 100 MHz. The 1N4148 comes in a DO-35 glass package for thru-hole mounting.
Paaji (verified owner) –
Good techinical knowledge
Jayen (verified owner) –
Good support and recommended
Viral (verified owner) –
Best cost electronic components in India
Akshay (verified owner) –
Good service.
Viral (verified owner) –
Good quality.
Komal (verified owner) –
Good quality.
Viral (verified owner) –
Best cost electronic components in India
Jayen (verified owner) –
Good techinical knowledge
Zohar (verified owner) –
Best cost electronic components in India
Shubham (verified owner) –
Good techinical knowledge
Zohar (verified owner) –
Good quality.
Lokesh (verified owner) –
Less cost than other websites
Komal (verified owner) –
I got my project done with these components Great Support