A4988 driver Stepper Motor Driver
₹115.05
The A4988 driver Stepper Motor Driver is a complete micro-stepping motor driver with built-in converter, easy to operate. It operates from 8Â V to 35Â V and can deliver up to approximately 1Â A per phase without a heat sink or forced air flow (it is rated for 2Â A per coil with sufficient additional cooling).
2 in stock
2 in stock
- Supply Voltage : 8-35 VDC.
- Current : 1.0A Â (no heatsink ).
- Current : 2.0A (with heat-sinking).
- logic input : 3 – 5.5V .
- Automatic current decay mode detection / choice.
- Mixed with slow current decay mode.
Related products
- Add to cart
A submersible pump (or sub pump, electric submersible pump (ESP)) is a device which has a hermetically sealed motor close-coupled to the pump body. The whole assembly is submerged in the fluid to be pumped. The main advantage of this type of pump is that it prevents pump cavitations’, a problem associated with a high elevation difference between pump and the fluid surface. Small DC Submersible water pumps push fluid to the surface as opposed to jet pumps having to pull fluids. Submersibles are more efficient than jet pumps.
Add to cartThis Chassis board is widely used as a mechanical frame structure of the mobile robots. It is the backbone of the robot, where we arrange and connect everything like motors, sensors, and wheels. It gives you the base to build our robot and allow you place your components according to requirements
- Add to cart
iny and lightweight with high output power. Servo can rotate approximately 180 degrees (90 in each direction), and works just like the standard kinds but smaller. You can use any servo code, hardware or library to control these servos.
- Add to cart
DC Motor – 60RPM – 12Volts geared motors are generally a simple DC motor with a gearbox attached to it. This can be used in all-terrain robots and variety of robotic applications. These motors have a 3 mm threaded drill hole in the middle of the shaft thus making it simple to connect it to the wheels or any other mechanical assembly.
- Add to cart
This is fully programmable 30A BLDC ESC with 5V, 3A BEC. Can drive motors with
continuous 30Amp load current. It has sturdy construction with 2 separate PCBs for
Controller and ESC power MOSFETs. It can be powered with 2-4 lithium Polymer batteries
or 5-12 NiMH / NiCd batteries. It has separate voltage regulator for the microcontroller for
providing good anti-jamming capability. It is most suitable for UAVs, Aircrafts and
Helicopters.
Reviews
There are no reviews yet.