5mm Yellow DIP LED
₹1.00
It is a 5mm Blue DIP LED. An LED is a two-lead semiconductor light source, which emits lights when activated. When an appropriate voltage is applied to the LED terminal, then the electrons are able to recombine with the electron holes within the device and release energy in the form of photons. This effect is known as electroluminescence. The color of the LED is determined by the energy bandgap of the semiconductor.
567 in stock
567 in stock
13 reviews for 5mm Yellow DIP LED
Related products
- Add to cartCore processor ESP8266 in smaller sizes of the module encapsulates Tensilica L106 integrates industry-leading ultra low power 32-bit MCU micro, with the 16-bit short mode, Clock speed support 80 MHz, 160 MHz, supports the RTOS, integrated Wi Fi MAC/BB/RF/PA/LNA, on-board antenna.
- Add to cart
Relays are output devices which are used to control or operate some external devices. This is a 5 volt Isolated relay module which means that there is a optocoupler used in between your control circuit and the relay thus protecting your circuit in case of any short circuit issues on the relay side.
- Add to cart
BC547 is a general purpose BJT NPN transistor mostly used in electronics hobbyists and educational electronics projects. Besides these uses it can also be used in commercial circuits. It comes in TO-92 packaging and the maximum output current this transistor can handle is 100mA. The transistor is having very good DC current gain and low noise capabilities due to which it is ideal to use in signal amplification stages. The typical saturation voltage is only 90 millivolts which is also a good sign to use it as a switch.
Add to cartThe 74HC595 consists of an 8−bit shift register and an 8−bit D−typelatch with three−state parallel outputs. The shift register accepts serialdata and provides a serial output. The shift register also providesparallel data to the 8−bit latch. The shift register and latch haveindependent clock inputs. This device also has an asynchronous resetfor the shift register.The HC595 directly interfaces with the SPI serial data port onCMOS MPUs and MCUs
- Add to cart
BC557 is a widely used PNP bipolar junction transistor manufactured in small TO-92 package. It is a general purpose PNP transistor that can be used as a switch or amplifier in electronic circuits. Its HFE ratings are 125 to 800 which makes it an ideal transistor to use as a small signal amplifier in electronic circuits for example for audio signal amplification or other, the HFE ratings of BC557 can be determined by the last letter after its number for example BC557A HFE ratings are 110-220, BC557B HFE ratings are 200-450 and BC557C HFE ratings are 420-800. The max collector dissipation is 500 milliwatt which is also an another good point to use it in amplification stages. Moreover it will also perform well when used it as a switch for load under 100mA. The transistor has also good collector to emitter (VCE) value that is -45V, therefore you can easily use it in circuits using 40 to 45 volts DC.
Jayen (verified owner) –
Drone parts i ordered and found ok
Akshay (verified owner) –
Less cost than other websites
Lokesh (verified owner) –
Online best cost electronic components
Vikas (verified owner) –
Good support and recommended
Priya (verified owner) –
Good quality.
Sneha (verified owner) –
Good techinical knowledge
Komal (verified owner) –
Very well worth the money.
Komal (verified owner) –
Good quality.
Devendra (verified owner) –
Good techinical knowledge
Roma (verified owner) –
The product is firmly packed.
Er.Prashant (verified owner) –
Good techinical knowledge
Lokesh (verified owner) –
Drone parts i ordered and found ok
Devendra (verified owner) –
Drone parts i ordered and found ok