Capacitor 2200uf 50v/63v Aluminium Electrolytic
₹30.56
91 in stock
91 in stock
Specification
: 330µF
:Â 250V
:Â LZ Series
: ± 20%
:Â Quick Connect, Snap-In
: 2000 hours @ 105°C
:Â Polar
:Â 22mm
11 reviews for Capacitor 2200uf 50v/63v Aluminium Electrolytic
You must be logged in to post a review.
Related products
- Add to cart
- Supply Voltage : 7V
- Input Voltage : 5.5V
- Operating Free Air Temperature Range : 0°C to +70°C
- Storage Temperature Range : −65°C to +150°C
Add to cartThe 74HC595 consists of an 8−bit shift register and an 8−bit D−typelatch with three−state parallel outputs. The shift register accepts serialdata and provides a serial output. The shift register also providesparallel data to the 8−bit latch. The shift register and latch haveindependent clock inputs. This device also has an asynchronous resetfor the shift register.The HC595 directly interfaces with the SPI serial data port onCMOS MPUs and MCUs
- Add to cart
- Widely used in small-scale as well as prototyping projects where 12 to 30 volts power supply needed
- Supports DC Power Jack: 2.1 x 5.5 mm
- Diameter: 14mm
Crystal Oscillator 8 MHZ
₹8.20Add to cartThis is a 8MHZ Crystal. This is a low cost crystal oscillator with oscillation frequency of 8Mhz. Crystal are normally required to provide clock pulses to your micro controller or other IC’s which require external clock source.
An oscillator crystal has two electrically conductive plates, with a slice or tuning fork of quartz crystal sandwiched between them. The crystal oscillator circuit sustains oscillation by taking a voltage signal from the quartz resonator, amplifying it, and feeding it back to the resonator. Quartz has the further advantage that its elastic constants and its size change in such a way that the frequency dependence on temperature can be very low.
Voltage Sensor Module 25VDC
₹61.12Add to cartThis DC Voltage Sensor Module is essentially a 5:1 potential divider circuit built using precession resistors for high accuracy.
The Arduino analog input is limited to a 5 VDC input. If you wish to measure higher voltages,this module allows you to measure voltages of 0-25V. Keep in mind, you are restricted to voltages that are less than 25 volts. More than that and you will exceed the voltage limit of your Arduino input.
Viral (verified owner) –
Very well worth the money.
Priya (verified owner) –
Good service.
Prakash (verified owner) –
Less cost than other websites
Viral (verified owner) –
Good techinical knowledge
Mayur (verified owner) –
Drone parts i ordered and found ok
Harsh (verified owner) –
Drone parts i ordered and found ok
Vikas (verified owner) –
Good support and recommended
Harsh (verified owner) –
Less cost than other websites
Ketan (verified owner) –
Less cost than other websites
Er.Prashant (verified owner) –
Good techinical knowledge
Ayush (verified owner) –
Good support and recommended