2 Pin 2.0mm JST Female Connector
₹10.00
Specification –
- Type: Female Connector
- No of Pins: 2
- Pitch: 2.0 mm
- Current Rating: 2 Ampere
- Wire Length: 28 cm
Sold out!
- This is a 2 pin female connector with wire for wire to board connector. This 2 PIN JST type female connector has a 2 mm pitch and a wire length of 28 cms. These 2mm JST connectors are designed to make high density connection of internal wires to printed circuit boards simple and are compact & highly reliable.
- These connectors are available in 2,3,4,5,6,8,10 way straight and Right Angle PCB Mounting along with corresponding female connectors.
Related products
Add to cartCore processor ESP8266 in smaller sizes of the module encapsulates Tensilica L106 integrates industry-leading ultra low power 32-bit MCU micro, with the 16-bit short mode, Clock speed support 80 MHz, 160 MHz, supports the RTOS, integrated Wi Fi MAC/BB/RF/PA/LNA, on-board antenna.
Add to cartThe DHT11 is a commonly used Temperature and humidity sensor. The sensor comes with a dedicated NTC to measure temperature and an 8-bit microcontroller to output the values of temperature and humidity as serial data. The sensor is also factory calibrated and hence easy to interface with other microcontrollers.
Add to cart2N2222 is NPN BJTÂ normally used in low power amplifiers and also for switching application.
2n2222 is used as a small signal transistor and used as a general purpose transistor and is very popular.  This is in TO-92 package form.
Add to cartThe 74HC595 consists of an 8−bit shift register and an 8−bit D−typelatch with three−state parallel outputs. The shift register accepts serialdata and provides a serial output. The shift register also providesparallel data to the 8−bit latch. The shift register and latch haveindependent clock inputs. This device also has an asynchronous resetfor the shift register.The HC595 directly interfaces with the SPI serial data port onCMOS MPUs and MCUs
Add to cartCrystal Oscillators are used as a quick and easy way to offer circuits a very accurate and consistent frequency output. This 16 MHz Crystal is a thru-hole type and is typically used with microcontrollers.
Reviews
There are no reviews yet.