18 Pin Dip Ic Socket-Base-Connector Electronic Component
₹4.00
18 Pin IC Socket base adaptor is an 18 pin IC holder, which can be soldered directly onto the PCB. The IC can be removed from this socket when required. The IC is placed on the socket at the time of use. This base acts as a removable IC holder.
133 in stock
133 in stock
12 reviews for 18 Pin Dip Ic Socket-Base-Connector Electronic Component
You must be logged in to post a review.
Related products
- Add to cart
Specification
- This relay module is 5 Volts active low.
- It is an 8-channel relay interface board, which can be controlled directly by a wide range of microcontrollers such as Arduino, AVR, PIC, ARM, PLC, etc.
- It is also able to control various appliances and other equipments with large current.
- Relay output maximum contact is AC250V 10A and DC30V 10A.
- Standard interface can be directly connected with microcontrollers.
- Red working status indicator lights are conducive to the safe use.
- Widely used for all MCU control, industrial sector, PLC control, smart home control.
- Input port IN1, IN2, IN3, IN4, IN5, IN6, IN7, IN8 low signal level effectively.
- VCC, GND : Input power.
- JD – VCC : Relay power input port,relay can power alone.
- Working voltage : 5V
- Module weight : about 112g
- package weight : about 150g
- module size : about 1.7cm X 5.5cm X 13.7cm(height * width * long)
- Add to cart
BC547 is a general purpose BJT NPN transistor mostly used in electronics hobbyists and educational electronics projects. Besides these uses it can also be used in commercial circuits. It comes in TO-92 packaging and the maximum output current this transistor can handle is 100mA. The transistor is having very good DC current gain and low noise capabilities due to which it is ideal to use in signal amplification stages. The typical saturation voltage is only 90 millivolts which is also a good sign to use it as a switch.
Add to cart2N2222 is NPN BJTÂ normally used in low power amplifiers and also for switching application.
2n2222 is used as a small signal transistor and used as a general purpose transistor and is very popular.  This is in TO-92 package form.
- Add to cart
The DHT11 is a commonly used Temperature and humidity sensor. The sensor comes with a dedicated NTC to measure temperature and an 8-bit microcontroller to output the values of temperature and humidity as serial data. The sensor is also factory calibrated and hence easy to interface with other microcontrollers.
- Add to cart
- Decade counter/decimal decode display (CD4017B)
- Binary counter/decoder
- Frequency division
- Counter control/timers
- Divde-by-N counting
- For further application information, see ICAN-6166 “COS/MOS MSI Counter and Register Design and Applications”
Shubham (verified owner) –
Good techinical knowledge
Jayen (verified owner) –
Good quality.
Sneha (verified owner) –
Good techinical knowledge
Akshay (verified owner) –
Less cost than other websites
Zohar (verified owner) –
Drone parts i ordered and found ok
Paaji (verified owner) –
I got my project done with these components Great Support
Priya (verified owner) –
Good support and recommended
Rohit (verified owner) –
The product is firmly packed.
Vikas (verified owner) –
Good support and recommended
Jayen (verified owner) –
The product is firmly packed.
Harsh (verified owner) –
I got my project done with these components Great Support
Priya (verified owner) –
Very fast delivery.