100K Ohm 3Pin Shaft Potentiometer
₹30.00 Original price was: ₹30.00.₹15.60Current price is: ₹15.60. + GST
It is a 100K Ohm 3Pin 15mm Shaft Potentiometer. This is used for adjusting various parameters like voltage, current, etc in an electronic circuit.
39 in stock
Purchase & earn 16 SmartX Rewards Coin!- Resistance: 100k??.
- Tolerance: 20%.
- Shaft Length: 15mm.
23 reviews for 100K Ohm 3Pin Shaft Potentiometer
You must be logged in to post a review.
Related products
- Rated 4.67 out of 5
DHT11 Module Temperature and Humidity sensor Module for boards compatible with Arduino, ARM and other MCU
₹120.00Original price was: ₹120.00.₹65.00Current price is: ₹65.00. + GSTPurchase & earn 65 SmartX Rewards Coin!Add to cartBuy nowThe DHT11 is a commonly used Temperature and humidity sensor. The sensor comes with a dedicated NTC to measure temperature and an 8-bit microcontroller to output the values of temperature and humidity as serial data. The sensor is also factory calibrated and hence easy to interface with other microcontrollers.
- Rated 4.00 out of 5
BC548 NPN 30V 0. 1A Transistor High quality
₹5.00Original price was: ₹5.00.₹1.23Current price is: ₹1.23. + GSTPurchase & earn 1 SmartX Rewards Coins!Add to cartBuy nowBC548 is another general purpose widely used transistor that can be easily get from reputable electronic components store, this transistor also have bunch of good features on the basis of which one can use it in their electronic circuit, it can handle maximum current of 500mA which is enough to drive many other components such as ICS, other transistors, portion of a circuits, relays, LEDs etc. The max collector dissipation of the device is 625 miliWatt which is another good feature to use it as a small amplifier.
- Rated 5.00 out of 5
8 Channel 5V Relay Board Expansion Module Optocoupler compatible UNO Raspberry
₹312.00Original price was: ₹312.00.₹246.16Current price is: ₹246.16. + GSTPurchase & earn 246 SmartX Rewards Coin!Add to cartBuy nowSpecification
- This relay module is 5 Volts active low.
- It is an 8-channel relay interface board, which can be controlled directly by a wide range of microcontrollers such as Arduino, AVR, PIC, ARM, PLC, etc.
- It is also able to control various appliances and other equipments with large current.
- Relay output maximum contact is AC250V 10A and DC30V 10A.
- Standard interface can be directly connected with microcontrollers.
- Red working status indicator lights are conducive to the safe use.
- Widely used for all MCU control, industrial sector, PLC control, smart home control.
- Input port IN1, IN2, IN3, IN4, IN5, IN6, IN7, IN8 low signal level effectively.
- VCC, GND : Input power.
- JD – VCC : Relay power input port,relay can power alone.
- Working voltage : 5V
- Module weight : about 112g
- package weight : about 150g
- module size : about 1.7cm X 5.5cm X 13.7cm(height * width * long)
- Rated 4.00 out of 5
Crystal Oscillator 8 MHZ
₹15.00Original price was: ₹15.00.₹6.72Current price is: ₹6.72. + GSTPurchase & earn 7 SmartX Rewards Coin!Add to cartBuy nowThis is a 8MHZ Crystal. This is a low cost crystal oscillator with?oscillation frequency of 8Mhz. Crystal are normally required to provide?clock pulses to your micro controller or other IC’s which require external clock?source.
An oscillator crystal has two electrically conductive plates, with a slice or?tuning fork of quartz crystal sandwiched between them. The crystal oscillator?circuit sustains oscillation by taking a voltage signal from the quartz?resonator, amplifying it, and feeding it back to the resonator. Quartz has the?further advantage that its elastic constants and its size change in such a way?that the frequency dependence on temperature can be very low.
- Rated 4.50 out of 5
Voltage Sensor Module 25VDC
₹16.00Original price was: ₹16.00.₹15.08Current price is: ₹15.08. + GSTPurchase & earn 15 SmartX Rewards Coin!Add to cartBuy nowThis DC Voltage Sensor Module is essentially a 5:1 potential divider circuit built using precession resistors for high accuracy.
The Arduino analog input is limited to a 5 VDC input.? If you wish to measure higher voltages,this module allows you to measure voltages of 0-25V. Keep in mind, you are restricted to voltages that are less than 25 volts. More than that and you will exceed the voltage limit of your Arduino input.
Devendra (verified owner) –
Very fast delivery.
Vikas (verified owner) –
The product is firmly packed.
Shubham (verified owner) –
Very well worth the money.
Priya (verified owner) –
Good quality.
Rohit (verified owner) –
Very fast delivery.
Zohar (verified owner) –
The product is firmly packed.
Viral (verified owner) –
Good techinical knowledge
Prakash (verified owner) –
The product is firmly packed.
Priya (verified owner) –
Good techinical knowledge
Priya (verified owner) –
Good service.
Priya (verified owner) –
Online best cost electronic components
Vikas (verified owner) –
Very fast delivery.
Roma (verified owner) –
Good techinical knowledge
Er.Prashant (verified owner) –
Best cost electronic components in India
Jayen (verified owner) –
Very well worth the money.
Er.Prashant (verified owner) –
Good service.
Lokesh (verified owner) –
I got my project done with these components Great Support
Komal (verified owner) –
Drone parts i ordered and found ok
Ayush (verified owner) –
The product is firmly packed.
Jayen (verified owner) –
Drone parts i ordered and found ok
Sneha (verified owner) –
The product is firmly packed.
Zohar (verified owner) –
Drone parts i ordered and found ok
Devendra (verified owner) –
I got my project done with these components Great Support