1W LED Diode White Emitting Diode 3.4V Chip Bulb Light
₹15.00
One Watt LED is like choosing a resistor. The Wattage of LED will be same no matter the manufacturing industry. The difference occurs in Temperature handling and Luminous Intensity output. Choosing the LED with Industrial standards is always better.
32 in stock
32 in stock
- Voltage applied between ANODE and CATHODE : 3.0 V to 3.5 V (Typical Operating Voltage : 3.3 V)
- Current through LED (Light Emitting Diode): 300mA to 350mA(350mA being absolute maximum forward current allowed through LED)
- Maximum reverse voltage between ANODE and CATHODE: 5 V
- Maximum Power dissipation: 1Watt
- Operating temperature: – 40 ºC to +80 ºC
- Operating LIFE : 100000 hours
1 review for 1W LED Diode White Emitting Diode 3.4V Chip Bulb Light
You must be logged in to post a review.
Related products
- Add to cart
The DHT11 is a commonly used Temperature and humidity sensor. The sensor comes with a dedicated NTC to measure temperature and an 8-bit microcontroller to output the values of temperature and humidity as serial data. The sensor is also factory calibrated and hence easy to interface with other microcontrollers.
- Add to cart
BC548 is another general purpose widely used transistor that can be easily get from reputable electronic components store, this transistor also have bunch of good features on the basis of which one can use it in their electronic circuit, it can handle maximum current of 500mA which is enough to drive many other components such as ICS, other transistors, portion of a circuits, relays, LEDs etc. The max collector dissipation of the device is 625 miliWatt which is another good feature to use it as a small amplifier.
Voltage Sensor Module 25VDC
₹61.12Add to cartThis DC Voltage Sensor Module is essentially a 5:1 potential divider circuit built using precession resistors for high accuracy.
The Arduino analog input is limited to a 5 VDC input. If you wish to measure higher voltages,this module allows you to measure voltages of 0-25V. Keep in mind, you are restricted to voltages that are less than 25 volts. More than that and you will exceed the voltage limit of your Arduino input.
- Add to cart
BC327 is a general purpose PNP BJP transistor that can be used for switching and amplification purposes in electronic circuits. The transistor features 800mA collector current hence it can be used to drive variety of loads in an electronic application. The max collector-emitter voltage is -45V therefore it can easily handle load voltage under 45V. Apart from that transistor also features 625mW collector dissipation and DC current gain of maximum 630 therefore it can also be used as an audio amplifier or for any type of signal amplification.
- Add to cart
- Widely used in small-scale as well as prototyping projects where 12 to 30 volts power supply needed
- Supports DC Power Jack: 2.1 x 5.5 mm
- Diameter: 14mm
Ayush (verified owner) –
Very well worth the money.