Search Results for: electronics circuits
Showing all 6 results
- Add to cartBuy now
Photodiodes, as the name suggest these are just another type of diodes. These diodes also have an anode and cathode just like normal LED. But, unlike LED?s these do not emit light. Instead, when they detect light they allow some current to flow through it. The amount of current that flows through the Photodiode is directly proportional the amount of light detected by the Photodiode.
Quartz Crystal Oscillator 16MHz HC-49S 2 Pin for TV, car Electronics, PC Card, Electronic Watch, DVD, MP3v
₹6.72 + GSTAdd to cartBuy nowCrystal Oscillators are used as a quick and easy way to offer circuits a very accurate and consistent frequency output. This 16 MHz Crystal is a thru-hole type and is typically used with microcontrollers.12x12x15mm Tactile Push Button Switch
₹10.80 + GSTAdd to cartBuy now- Through-hole design.
- Shaft Shape: Round
- High operating force (3.0N or 3.6N) suited to automotive equipment requirements
- The long life of 300,000 cycles realized despite the high operating force
- Middle stroke (1.05mm)
- Used in the fields of electronic products, household appliances and more.
- High precision mechanism design offers acute operation and long service life.
- Compact and lightweight, easy to carry and dismantling.
- Good electrical conductivity.
LM358 IC – (SMD Package) – Low Power Dual Op-Amp IC
₹10.40 + GSTAdd to cartBuy now- The LM358 series consists of two independent, high gain, internally frequency compensated operational amplifiers which were designed specifically to operate from a single power supply over a wide range of voltages. Operation from split power supplies is also possible and the low power supply current drain is independent of the magnitude of the power supply voltage. Application areas include transducer amplifiers, dc gain blocks and all the conventional op amp circuits which now can be more easily implemented in single power supply systems. For example, the LM358 series can be directly operated off of the standard +5V power supply voltage which is used in digital systems and will easily provide the required interface electronics without requiring the additional ±15V power supplies. The LM358 is also available in a chip sized package (8-Bump micro SMD) using National’s micro SMD package technology.
1N5408 1000V 3A Power Rectifier Diode
₹3.28 + GSTAdd to cartBuy nowA diode is a device which allows current flow through only one direction. That is the current should always flow from the Anode to cathode. The cathode terminal can be identified by using a grey bar as shown in the picture above.
The b is called a power diode because of its high forward current and reverse voltage with a power dissipation of 6.25W. For 1N5408 Diode, the maximum current carrying capacity is 3A it withstand peaks up to 200A. Hence we can use this in circuits that are designed for less than 3A.? The reverse current is 10uA which is negligible. These diodes have a slow recovery time so in modern electronics it is being replaced by other advanced diodes.
BC547 NPN General Purpose Transistor
₹0.98 + GSTAdd to cartBuy nowBC547 is a general purpose BJT NPN transistor mostly used in electronics hobbyists and educational electronics projects. Besides these uses it can also be used in commercial circuits. It comes in TO-92 packaging and the maximum output current this transistor can handle is 100mA. The transistor is having very good DC current gain and low noise capabilities due to which it is ideal to use in signal amplification stages. The typical saturation voltage is only 90 millivolts which is also a good sign to use it as a switch.