By using high-quality components, such as automotive power MOSFETs from Infineon, engineers and automakers keep MOSFET-related failures to an absolute minimum. Our commitment to our customers’ success and to overall road safety is proven by the fact that all automotive MOSFETs bearing our name uphold the highest-possible quality standards, far beyond AEC-Q101.
₹16.00Original price was: ₹16.00.₹15.08Current price is: ₹15.08. + GST
This DC Voltage Sensor Module is essentially a 5:1 potential divider circuit built using precession resistors for high accuracy.
The Arduino analog input is limited to a 5 VDC input.? If you wish to measure higher voltages,this module allows you to measure voltages of 0-25V. Keep in mind, you are restricted to voltages that are less than 25 volts. More than that and you will exceed the voltage limit of your Arduino input.
₹15.00Original price was: ₹15.00.₹6.72Current price is: ₹6.72. + GST
Crystal Oscillators are used as a quick and easy way to offer circuits a very accurate and consistent frequency output. This 16 MHz Crystal is a thru-hole type and is typically used with microcontrollers.
₹400.00Original price was: ₹400.00.₹240.50Current price is: ₹240.50. + GST
Flex sensors are usually available in two sizes. One is 2.2 inch and another is 4.5 inch. Although the sizes are different the basic function remains the same. They are also divided based on resistance. There are LOW resistance, MEDIUM resistance and HIGH resistance types. Choose the appropriate type depending on requirement. ?Here we are going to discuss 2.2inch Flex sensor that is FS-L-0055.
₹312.00Original price was: ₹312.00.₹246.16Current price is: ₹246.16. + GST
Specification
This relay module is 5 Volts active low.
It is an 8-channel relay interface board, which can be controlled directly by a wide range of microcontrollers such as Arduino, AVR, PIC, ARM, PLC, etc.
It is also able to control various appliances and other equipments with large current.
Relay output maximum contact is AC250V 10A and DC30V 10A.
Standard interface can be directly connected with microcontrollers.
Red working status indicator lights are conducive to the safe use.
Widely used for all MCU control, industrial sector, PLC control, smart home control.
Input port IN1, IN2, IN3, IN4, IN5, IN6, IN7, IN8 low signal level effectively.
VCC, GND : Input power.
JD – VCC : Relay power input port,relay can power alone.
Working voltage : 5V
Module weight : about 112g
package weight : about 150g
module size : about 1.7cm X 5.5cm X 13.7cm(height * width * long)