2 Meter UL1007 23AWG PVC Electronic Wire (Red)
₹23.80 + GST
| Cable Length (Meter) | 2 |
| Cable Size (AWG) | 23 |
| Color | Red |
| Conductor Material | Tinned Copper |
| Insulation Material | PVC |
| Shipment Weight | 0.06 kg |
| Shipment Dimensions | 12 ? 6 ? 4 cm |
1 in stock
- This cable serves specific application areas accounting to its PVC coating.
- The use of PVC coating blends these wires with special properties such as self ? extinguishing and flame retardant, also Conditionally resistant to oils, solvents, acids, and dyes.
- The UL1007 23AWG PVC Wire is used in household wiring application such as switchboards, electronic and electrical equipment.
- This PVC wire comes with Annealed plain or tinned stranded copper conductor. So, the conductors remain same as found in our silicon coated wires.
1 review for 2 Meter UL1007 23AWG PVC Electronic Wire (Red)
You must be logged in to post a review.
Related products
- Add to cart
This is a?100 x 2.5 mm Nylon cable tie?also known as hose tie or Zip tie. The?cable tie?is perfect for holding items together specially electric cables or wires.? The flexible design of the?cable tie?makes it easier to slip the ties under and around wire harness. Thanks to the teeth on one of the side of the belt makes it easier for self locking and securing the wires.
BC327 PNP General Purpose Amplifier Transistor
₹1.95 + GSTAdd to cartBC327 is a general purpose PNP BJP transistor that can be used for switching and amplification purposes in electronic circuits. The transistor features 800mA collector current hence it can be used to drive variety of loads in an electronic application. The max collector-emitter voltage is -45V therefore it can easily handle load voltage under 45V. Apart from that transistor also features 625mW collector dissipation and DC current gain of maximum 630 therefore it can also be used as an audio amplifier or for any type of signal amplification.
5.5mm x 2.1mm 3 Pin Female DC Power Jack Panel Mount Screw Nut Kit DC Socket Electrical Plug
₹8.20 + GSTAdd to cart- Widely used in small-scale as well as prototyping projects where 12 to 30 volts power supply needed
- Supports DC Power Jack: 2.1 x 5.5 mm
- Diameter: 14mm
Voltage Sensor Module 25VDC
₹50.12 + GSTAdd to cartThis DC Voltage Sensor Module is essentially a 5:1 potential divider circuit built using precession resistors for high accuracy.
The Arduino analog input is limited to a 5 VDC input.? If you wish to measure higher voltages,this module allows you to measure voltages of 0-25V. Keep in mind, you are restricted to voltages that are less than 25 volts. More than that and you will exceed the voltage limit of your Arduino input.
Crystal Oscillator 8 MHZ
₹6.72 + GSTAdd to cartThis is a 8MHZ Crystal. This is a low cost crystal oscillator with?oscillation frequency of 8Mhz. Crystal are normally required to provide?clock pulses to your micro controller or other IC’s which require external clock?source.
An oscillator crystal has two electrically conductive plates, with a slice or?tuning fork of quartz crystal sandwiched between them. The crystal oscillator?circuit sustains oscillation by taking a voltage signal from the quartz?resonator, amplifying it, and feeding it back to the resonator. Quartz has the?further advantage that its elastic constants and its size change in such a way?that the frequency dependence on temperature can be very low.
Paaji (verified owner) –
I got my project done with these components Great Support